Frigidaire FPHB2899LF4 ユーザーズマニュアル

CAUTION

If the water supply to your refrigerator is softened, be

sure the softener is properly maintained. Chemicals

from a water softener can damage the ice maker.

CAUTION

NEVER use an ice pick or similar sharp instrument to

break up the ice. This could damage the ice bin and

dispenser mechanism.
To loosen stuck ice, use warm water. Before replacing

the ice bin, make sure it is completely dry.

IMPORTANT

When removing or replacing the ice bin, DO NOT rotate

the auger in the ice bin. If the auger is accidentally rotated,

you must realign the auger by turning it in 45 degree turns

(see below) until the ice bin fits into place with the drive

mechanism. If the auger is not properly aligned when

replacing the ice bin, the refrigerator will not dispense ice.

The fresh food door also may not close properly causing

warm air to leak into the fresh food compartment.

IMPORTANT

You may want to change your ice cube size per your

preference or if you have low water pressure in your

home. The ice cube size function allows you to change

the cube size from the display panel. There are three

sizes: 1, 2, and 3. The factory default is 1 (smallest).

This size should work well in most cases. If your water

pressure is low or you simply prefer a larger size, then

you can change to size 2. Size 3 should ONLY be used

in the case of very low water pressure. Using size 3

with high water pressure (above 70 psi) could result in

overfilling the ice maker. The excess water will spill into

the ice bin causing the existing ice to clump together.

AUTOMATIC ICE & WATER DISPENSER (CONTINUED)

To change cube size

1 Quickly press the CUBE button twice. You will see

one dash in the refrigerator temperature display.

The freezer temperature display will show ICE.

2 Press the refrigerator Up (^) and Down (v) buttons

to change the size. One dash will produce small

cubes, two dashes will produce medium cubes and

three dashes will produce large cubes.

3 Press the CUBE button again to save the setting.

Ice maker/dispenser tips

• If your refrigerator is not connected to a water

supply or the water supply is turned off, turn off

the ice maker by holding the On/Off soft-touch

icon for three (3) seconds.

• The following sounds are normal when the ice

maker is operating:

- Motor running

- Ice dropping into ice bin

- Water valve opening or closing

- Running water

• When dispensing ice, you will hear a snapping or

clicking sound when the ice chute opens and closes.

• If you need a large quantity of ice at one time, it is

best to get cubes directly from the ice bin.

• Ice cubes stored too long may develop an odd

flavor. Empty the ice bin as explained below.

• When dispensing cubed ice, it is normal to have a small

quantity of little pieces along with the whole cubes.

Cleaning the ice maker

Clean the ice maker and ice bin at regular intervals,

especially prior to vacation or moving.

Adjusting Ice Bin Auger

Removing Ice Bin

1 Turn off the ice maker.
2 Remove the ice bin by

pulling straight out.

3 Empty and carefully

clean the ice bin with

mild detergent. Do not

use harsh or abrasive

cleaners. Rinse with

clear water.

4 Allow the ice bin to

dry completely before

replacing in the freezer.

5 Replace the ice bin. Turn the ice maker on.
Remove and empty the ice bin if:

• An extended power failure (one hour or longer)

causes ice cubes in the ice bin to melt and freeze

together, jamming the dispenser mechanism.

• You do not use the ice dispenser frequently. Ice

cubes will freeze together in the bin, jamming the

dispenser mechanism.

Remove the ice bin and shake to loosen the cubes or

clean as explained above.