Kingston Technology Beast 32GB DDR3-1866MHz KHX18C10T3K4/32X プリント
製品コード
KHX18C10T3K4/32X
DESCRIPTION
Kingston's KHX18C10T3K4/32X is a kit of four 1G x 64-bit
(8GB) DDR3-1866 CL10 SDRAM (Synchronous DRAM) 2Rx8
memory modules, based on sixteen 512M x 8-bit DDR3 FBGA
components per module. Each module kit supports Intel
®
XMP
(Extreme Memory Profiles). Total kit capacity is 32GB. Each
module kit has been tested to run at DDR3-1866 at a low
latency timing of 10-10-10 at 1.5V. The SPDs are programmed
to JEDEC standard latency DDR3-1600 timing of 11-11-11 at
1.5V. Each 240-pin DIMM uses gold contact fingers and
requires +1.5V. The JEDEC standard electrical and mechanical
specifications are as follows:
Document No. 4806605-001.A00 11/08/12 Page 1
SPECIFICATIONS
CL(IDD)
11 cycles
Row Cycle Time (tRCmin)
48.125ns (min.)
Refresh to Active/Refresh
260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin)
35ns (min.)
Maximum Operating Power
2.580 W* (per module)
UL Rating
94 V - 0
Operating Temperature
0
o
C to 85
o
C
Storage Temperature
-55
o
C to +100
o
C
*Power will vary depending on the SDRAM used.
FEATURES
•
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
•
VDDQ = 1.5V (1.425V ~ 1.575V)
•
800MHz fCK for 1600Mb/sec/pin
•
8 independent internal bank
•
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
•
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•
8-bit pre-fetch
•
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
•
Bi-directional Differential Data Strobe
•
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
•
On Die Termination using ODT pin
•
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
•
Asynchronous Reset
•
PCB : Height 1.827” (46.41mm) w/ heatsink, double sided
component
component
Memory Module Specifi cations
KHX18C10T3K4/32X
32GB (8GB 1G x 64-Bit x 4 pcs.)
DDR3-1866 CL10 240-Pin DIMM Kit
DDR3-1866 CL10 240-Pin DIMM Kit
Continued >>
XMP TIMING PARAMETERS
•
JEDEC: DDR3-1600 CL11-11-11 @1.5V
•
XMP Profile #1: D3-1866 CL10-10-10 @1.5V
•
XMP Profile #2: D3-1600 CL9-9-9 @1.5V