HP DL560 G8 686785-001 ユーザーズマニュアル
製品コード
686785-001
On System Management
Processor
Processor
HP iLO (Firmware: HP iLO 4)
NOTE: For more information, visit:
Memory Protection
Advanced ECC
NOTE: Advanced ECC uses single device data correction (SDDC) to detect and correct single and all multi-
bit error that occurs within a single DRAM chip. Both x4 and x8 SDDC are supported (x8 requires lockstep
mode).
bit error that occurs within a single DRAM chip. Both x4 and x8 SDDC are supported (x8 requires lockstep
mode).
Online Spare
NOTE: Memory online spare mode (also known as rank spare mode) detects a rank that is degrading and
switches operation to the spare rank.
switches operation to the spare rank.
Lock-step mode
NOTE: Memory Lockstep mode is used to correct a single x8 DRAM device failure on a DIMM. The DIMMs in
each paired memory channel must have identical HP part numbers.
each paired memory channel must have identical HP part numbers.
Memory
One of the following
depending on Model
depending on Model
Type
HP SmartMemory
DDR3 Load Reduced (LRDIMM), Registered (RDIMM)
DDR3 Load Reduced (LRDIMM), Registered (RDIMM)
DIMM Slots Available
48 (12 DIMM slots per processor /4 channels per processor/3 DIMMs per
channel)
channel)
Standard (Entry Model)
16GB (1x4GB) PC3L-10600R (DDR3-1333) Registered DIMMS
Standard (Base Models)
32GB (4x4GB) PC3L-10600R (DDR3-1333) Registered DIMMS
Standard (High
Performance Models)
Performance Models)
64GB (4x8GB) PC3-12800R (DDR3-1600) Registered DIMMS
Maximum Capacity
(RDIMM)
(RDIMM)
1.5TB (48x 32GB RDIMM @1600MHz)
NOTE: HP memory from previous generation servers are not qualified or warranted with this HP ProLiant
Server. HP SmartMemory is required to realize the memory performance improvements and enhanced
functionality listed in this document for Gen8. For additional information, please see the HP SmartMemory
QuickSpecs at:
Server. HP SmartMemory is required to realize the memory performance improvements and enhanced
functionality listed in this document for Gen8. For additional information, please see the HP SmartMemory
QuickSpecs at:
NOTE: LRDIMM, RDIMM are all distinct memory technologies and cannot be mixed within a server. The
majority of ProLiant Gen8 servers support RDIMM, UDIMM and LRDIMM.
NOTE: If only one processor is installed, only a quarter the DIMM slots are available. If only two processors
are installed, only half the DIMM slots are available.
NOTE: Depending on the memory configuration and processor model, the memory speed may run at
1600MHz, 1333MHz, or 1066MHz. Please see Memory Population Table or the Online Memory
Configuration Tool at:
majority of ProLiant Gen8 servers support RDIMM, UDIMM and LRDIMM.
NOTE: If only one processor is installed, only a quarter the DIMM slots are available. If only two processors
are installed, only half the DIMM slots are available.
NOTE: Depending on the memory configuration and processor model, the memory speed may run at
1600MHz, 1333MHz, or 1066MHz. Please see Memory Population Table or the Online Memory
Configuration Tool at:
Network Controller
One of the following
depending on Model
depending on Model
HP ProLiant Gen8 servers offer a new networking technology - Flexible Network Technology. The HP ProLiant
DL560 Gen8 server offers the customer the choice of 1 Gigabit and/or 10 Gigabit networking solutions. For
additional details see the Networking Section of this document.
Entry Models
DL560 Gen8 server offers the customer the choice of 1 Gigabit and/or 10 Gigabit networking solutions. For
additional details see the Networking Section of this document.
Entry Models
HP Ethernet 1Gb 4-port 331FLR Adapter
Base Models
HP Ethernet 1Gb 4-port 331FLR Adapter
High Performance Models
HP Ethernet 1Gb 4-port 331FLR Adapter
HP Ethernet 10Gb 2-port 530FLR-SFP+ Adapter
HP Ethernet 10Gb 2-port 530FLR-SFP+ Adapter
QuickSpecs
HP ProLiant DL560 Generation8 (Gen8)
Standard Features
DA - 14395 North America — Version 8 — December 10, 2012
Page 3