Tandberg Data Streamer SCSI DLT-V4 Internal Grey 7301 7088 00 ユーザーズマニュアル
製品コード
7301 7088 00
Chapter 4 Using Your Tape Drive
LED Indicators
DLT-V4 Product Manual
48
during POST, the
Ready
LED flashes until the tape drive executes a mid-
tape load, which can take several minutes. As POST completes, the tape
drive makes a faint buzzing noise for several seconds. The noise
associated with this activity is normal for this technology and does not
indicate a problem with the tape drive.
Normal Operation —
Ready LED Indicator
Activity
Ready LED Indicator
Activity
4
During normal operation, the
Ready
LED displays one of the three
following states. The
Ready
LED acts independently of the other LEDs.
Table 13 Ready LED Indicator
Activity
Activity
Normal Operation — Fault /
Clean / Media LEDs
Indicator Activity
Clean / Media LEDs
Indicator Activity
4
The
Fault
,
Clean
, and
Media
LEDs work together to display the status of
the tape drive.
Table 14 Fault / Clean / Media
LEDs Indicator Activity
LEDs Indicator Activity
State
Description
Off
Indicates that there is no power to the tape drive.
On
Indicates that power is on, no data cartridge is
loaded, or a loaded data cartridge is idle with no
tape motion.
Blinking
A data cartridge is in the process of loading, or
there is tape motion on a loaded data cartridge.
Tape motion includes reading, writing, locating,
rewinding, calibrating, and so on.
Fault
Clean
Media
Description
–
Unsupported format, unsupported
data cartridge type, or damaged data
cartridge
A DLT1 (DLT VS 80) formatted
DLTtape IV data cartridge is loaded.
Represents a read-only or VS160
formatted cartridge.
–
Calibration error or permanent write/
read error, cleaning suggested