Zebra HW46211 ユーザーズマニュアル

13185L-002 Rev. A  1/24/06

110XiIIIPlus Maintenance Manual

Page 4-63

Maintenance

Section 4

Install the Cutter Motor

1. Refer to 

. Thread the motor power lead through the slot in the main 

frame.

2. Install the split grommet onto the motor power lead and into the hole in the main 

frame.

3. Hold the lower drive arm to allow the cutter motor shaft to slide through the hole in 

the drive arm as the motor is being installed.

4. Secure the motor to the main frame with the motor mounting screws.

5. Carefully rotate the slotted link counter clockwise until the lower drive arm is 

vertical and the flag is positioned between the walls of the sensor.

6. Refer to 

. Hold the lower drive arm in its vertical position and rotate the 

motor shaft until the two set screws are aligned with the two flats on the shaft.

7. Ensure the sensor flag is centered between the walls of the sensor and tighten the set 

screws to 20 inch-pounds (2.3 N•m) of torque.

8. Refer to 

. Thread the power lead behind the lower right corner of the 

cutter PCB. Install the screw in the lower right corner. Tighten all four screws.

9. Connect the cutter motor power lead to cutter PCB connector J4.

10. Reinstall the AC/DC power supply. Ensure all wires are positioned away from any 

moving parts.

11. Refer to 

. Reconnect all cables to the power supply and ensure proper 

placement and orientation.

12. Refer to 

. Reinstall the electronics cover.

13. Reconnect the AC power cord.

Cutter Motor

Shaft

Ferrite Ring

Grommet

Allen Screw

Motor Mounting

Screws

Cutter Motor

Lower

Drive

Arm

Long Drive

Link

E-Ring

E-Ring

E-Ring

Pivot Pin

Bearing

Flat Washer

Mounting Post

Slotted Link

Clamp

Cutter Optical Sensor