IBM Flex System V7000 Expansion Enclosure 4939H29 ユーザーズマニュアル
製品コード
4939H29
8068ch06-Volumes.fm
Draft Document for Review January 29, 2013 12:52 pm
256
IBM Flex System V7000 Storage Node Introduction and Implementation Guide
Figure 6-22 Compressed Volume- CLI command displays
5. After the task is completed, click Close
You can choose to map the new volumes immediately as part of the volume create wizard by
clicking Create and Map to Host. This will guide you through the Map to Host wizard
described in section 6.3, “Mapping a volume to the host” on page 261.
clicking Create and Map to Host. This will guide you through the Map to Host wizard
described in section 6.3, “Mapping a volume to the host” on page 261.
For more information about Real-time Compression in IBM Flex System V7000 Storage Node
as well as IBM Storwize V7000 and IBM SAN Volume Controller check Real-time
Compression in SAN Volume Controller and Storwize V7000, REDP-4859.
as well as IBM Storwize V7000 and IBM SAN Volume Controller check Real-time
Compression in SAN Volume Controller and Storwize V7000, REDP-4859.
6.2 Creating a new host
Before we can map any volumes to a host, the host has to be created first. We here
demonstrate how to create new hosts in the IBM Flex System V7000 Storage Node.
demonstrate how to create new hosts in the IBM Flex System V7000 Storage Node.
6.2.1 Create a Fibre Channel attached host
To create the Fibre Channel host do the following:
1. Navigate to the Hosts tab of the IBM Flex System V7000 Storage Node GUI and click
New Host as shown in Figure 6-23 on page 257.