IBM Flex System V7000 Expansion Enclosure 4939H29 ユーザーズマニュアル
製品コード
4939H29
8068ch07-Migration.fm
Draft Document for Review January 29, 2013 12:52 pm
288
IBM Flex System V7000 Storage Node Introduction and Implementation Guide
Figure 7-27 Disks are returned as unmanaged MDisks
You can now un-zone and remove the older storage system from the IBM Flex System V7000
Storage Node.
Storage Node.
For more information about the IBM Flex System V7000 Storage Node migration function,
refer to Chapter 10, “Volume Mirroring and Migration” on page 423.
refer to Chapter 10, “Volume Mirroring and Migration” on page 423.
After the migration is Finalized, the Migration Pool used for the migration remain as a Storage
Pool on the system and is empty. It can be deleted at this time or it can simply be left unused.
Pool on the system and is empty. It can be deleted at this time or it can simply be left unused.
As the volume name of the migrated disk is automatically determined by the Storage
Migration Process, and if you did not rename the disk during the Wizard this is now a good
time to rename the volume to a name that reflects what it is used for. For an example of how
to rename a volume refer to 7.2.7, “Renaming the volume” on page 291
Migration Process, and if you did not rename the disk during the Wizard this is now a good
time to rename the volume to a name that reflects what it is used for. For an example of how
to rename a volume refer to 7.2.7, “Renaming the volume” on page 291
7.2.6 Mapping to host performed after the Migration has begun
If you did not map the disk to the host during the migration Wizard, mapping can be
performed now. Follow these steps to map the disk:
performed now. Follow these steps to map the disk:
Figure 7-28 on page 289 shows how to navigate to Pools
Volumes By Pool from
where we locate the volume being migrated - right click the volume and click Map to Host.
The same can be done by selecting the volume and from the Actions menu select Map to
Host.
The same can be done by selecting the volume and from the Actions menu select Map to
Host.