IBM Flex System V7000 Expansion Enclosure 4939H29 ユーザーズマニュアル
製品コード
4939H29
Chapter 12. Host Configuration
475
Draft Document for Review January 29, 2013 12:52 pm
8068ch12-Host Config.fm
12.2 Discovering the volumes from the host and Multipath
settings
settings
This section shows how to discover host mapped volumes from the host
We assume that you have completed all previous steps so that the hosts and the IBM Flex
System V7000 Storage Node are prepared:
System V7000 Storage Node are prepared:
��
Prepare your operating systems for attachment by installing the appropriate multipath
driver if needed. Use the System Storage Interoperability Center (SSIC) to check which
code levels are supported to attach your host to your storage. SSIC is a web tool that
checks the interoperation of host, storage, switches, and multipathing drivers. It can be
found at the following address:
driver if needed. Use the System Storage Interoperability Center (SSIC) to check which
code levels are supported to attach your host to your storage. SSIC is a web tool that
checks the interoperation of host, storage, switches, and multipathing drivers. It can be
found at the following address:
��
Perform basic volume configuration.
��
Create hosts using the GUI.
��
Perform host mapping.
Refer to Chapter 6, “Basic Volume and Host Configuration” on page 241 for more information.
In the IBM Flex System V7000 Storage Node GUI, click Hosts
All Hosts (Figure 12-1).
Figure 12-1 Open all hosts