ABUS Xevox 360° BW8085 プリント
製品コード
BW8085
Xevox 360°
Art. no. BW8085
• Microprocessor-controlled PIR sensor with 360° detection range
• High room exploitation
• Detection diameter: 13 m diameter at 4 m height
• Walk-test function
• Tamper protection
• High room exploitation
• Detection diameter: 13 m diameter at 4 m height
• Walk-test function
• Tamper protection
The Xevox 360° is a motion sensor with one PIR sensor. It reacts to heat movement and reports it to the alarm
panel. Installed on the ceiling, this sensor monitors the whole room. With a detection range of 360°, these
sensors have the complete room under control. The aperture angle of the lens is 110°. For example: If the Xevox
360° is installed at a height of 4 meters, it monitors a cone-shaped space with a diameter of 13 meters at ground
level. At 1.2 meters above the ground, the diameter of the monitored area is 8 meters. It is particularly suitable
for monitoring large, underground corridors. The optimum installation location of the Xevox 360° is the center of
the ceiling. The intruder's possible direction of movement should be at right-angles to the sensor. Do not install
the sensor near to sources of heat. By means of a jumper, you can change the sensitivity of the Xevox 360°
motionsensor. This way you can define the number of pulses that have to be detected before the sensor opens
the alarm relay.
panel. Installed on the ceiling, this sensor monitors the whole room. With a detection range of 360°, these
sensors have the complete room under control. The aperture angle of the lens is 110°. For example: If the Xevox
360° is installed at a height of 4 meters, it monitors a cone-shaped space with a diameter of 13 meters at ground
level. At 1.2 meters above the ground, the diameter of the monitored area is 8 meters. It is particularly suitable
for monitoring large, underground corridors. The optimum installation location of the Xevox 360° is the center of
the ceiling. The intruder's possible direction of movement should be at right-angles to the sensor. Do not install
the sensor near to sources of heat. By means of a jumper, you can change the sensitivity of the Xevox 360°
motionsensor. This way you can define the number of pulses that have to be detected before the sensor opens
the alarm relay.
Page 1 of 2
Technical alterations reserved. Misprints and errors excepted. Copyright. © ABUS 07/2013