Philips AVENT Comfort Manual breast pump SCF330/12 SCF330/12 ユーザーズマニュアル

 - The breast pump is only intended for repeated use by a single user.

 - Never drop or insert any foreign object into any opening.

 - Never use any accessories or parts from other manufacturers or that Philips AVENT does 

not specifically recommend. If you use such accessories or parts, your guarantee becomes 

invalid.

 - Wash, rinse and sterilise all pump parts before each use.

 - Do not use antibacterial or abrasive cleaning agents when you clean breast pump parts.

 - Do not continue pumping for more than five minutes at a time if you do not succeed in 

expressing any milk.

 - If the pressure generated is uncomfortable or causes pain, break the seal between the breast 

and the pump body with your finger and remove the pump from your breast.

Clean and sterilise all parts of the breast pump before first use as described in chapter ‘Cleaning 

and sterilising’. Clean all parts after each subsequent use and sterilise all parts before each 

subsequent use.

thoroughly before you handle the cleaned parts.
Be careful, the cleaned parts may still be hot.
Tip: You may find it easier to assemble the breast pump while it is wet.

 1 

 Insert the white valve into the pump body from underneath. Push in the valve as far as 

possible (Fig. 2).

 2 

 Screw the pump body clockwise onto the bottle or storage cup until it is securely 

fixed (Fig. 3).

 3 

 Place the silicone diaphragm with stem into the pump body from above. Make sure it fits 

securely around the rim by pressing down with your fingers to ensure a perfect 

seal (Fig. 4).

 4 

 Attach the handle onto the diaphragm with stem by hooking the hole in the handle over 

the end of the stem. Push down the handle onto the pump body until it clicks into 

place (Fig. 5).

 5 

 Place the massage cushion into the funnel-shaped section of the pump body. Push in the 

inner part of the massage cushion as far as possible and make sure that it is perfectly 

sealed all around the rim of the pump body. Press in between the petals to remove any 

trapped air (Fig. 6).

7