ZyXEL 202H 91-003-194001B ユーザーズマニュアル

P-202H Plus v2 User’s Guide

Chapter 22 Dial-in Setup

204

Compression

Turn on/off Stac Compression. The default for this field is No.

Mutual Authen

Some vendors, e.g., Cisco, require mutual authentication, i.e., the node that 

initiates the call will request a user name and password from the far end that it is 

dialing to. If the remote node requires mutual authentication, set this field to Yes.

O/G Username

Enter the login name to be used to respond to the peer’s authentication request.

O/G Password

Enter the outgoing password to be used to respond to the peer’s authentication 

request.

Multiple Link 

Options:

Max Trans 

Rate(Kbps)

Enter the maximum data transfer rate between your ZyXEL Device and the remote 

dial-in user. 
64 - At most, one B channel is used. 
128 - A maximum of two channels can be used. When the ZyXEL Device calls 

back to the remote dial-in user, the maximum data transfer rate is always 64.

Callback Budget 

Management:

Allocated Budget 

(min)

This field sets the budget callback time for all the remote dial-in users. The default 

for this field is 0 for no budget control.

Period (hr)

This field sets the time interval to reset the above callback budget control.

IP Address 

Supplied By:

Dial-in User

If set to Yes, the ZyXEL Device will allow a remote host to specify its own IP 

address.
If set to No, the remote host must use the IP address assigned by your ZyXEL 

Device from the IP pool, configured below. This is to prevent the remote host from 

using an invalid IP address and potentially disrupting the whole network.

IP Pool

This field tells your ZyXEL Device to provide the remote host with an IP address 

from the pool. This field is required if Dial-In IP Address Supplied By: Dial-in 

User is set to No. You can configure this field even if Dial-in User is set to Yes, in 

which case your ZyXEL Device will accept the IP address if the remote peer 

specifies one; otherwise, an IP address is assigned from the pool.

IP Start Addr

This field is applicable only if you selected Yes in the Dial-In IP Address 

Supplied By: IP Pool field.
The IP pool contains contiguous IP addresses and this field specifies the first one 

in the pool. The IP start address is the start of a series of consecutive IP 

addresses.

IP Count (1, 4)

In this field, enter the number (1 to 4) of addresses in the IP pool. For example, if 

the starting address is 192.168.135.5 and the count is 2, then the pool will have 

192.68.135.5 and 192.68.135.6. The IP count is the number of consecutive IP 

addresses allowed.

Session Options:

Table 71   Menu 13 Default Dial-in Setup