Bosch AL1002WAL ユーザーズマニュアル

Each output can be independently programmed for
Steady, Temporal Code 3, or Strobe synchronization.
All outputs can be programmed for Input to Output
Follower mode.

An individual output of 4 A can be obtained by
paralleling two outputs.

The two-wire synchronization mode works with the
Gentex Commander GOS Sync Mode 3, 4 and ST/HS
series; the System Sensor SpectrAlert series of horns,
strobes, and horn strobe combinations; and Cooper
Wheelock horns, strobes, and horn strobe
combinations to provide a means of synchronizing the
temporal-coded horns, synchronizing the flash timing
of the strobe, and silencing the horns of the horn
strobe combination over a two-wire circuit while
leaving the strobes active.

Notice
The AL1002WAL will synchronize only the horns,
horn strobes and strobes that contain
synchronization capability.

Altronix Corp. holds these Listings and Approvals:

 

NFPA

Complies with NFPA 72

USA

UL

UOXX: Control Unit Accessories, System

(UL864)

FM

AL1002WAL

CSFM

see our website

NYC-

MEA

220-95-E, Vol. 11

Quant.

Component

1

NAC power extender

1

AL800LGK9E Logic Board

1

Enclosure (red)

1

Cam lock

1

Set of battery leads

1

Hardware pack

1

Literature pack

Dimensions:

15.5 in. high x 12 in. wide x 4.5 in. deep

(39.4 cm high x 30.5 cm wide x 11.4 cm deep)

Weight:

17 lbs (7.7 kg)

All hardware and software product names used in this
document are likely to be registered trademarks and
must be treated accordingly.

AL1002WAL NAC Power Extender (10 A)
10 A remote power supply/battery charger that can be
connected to any 12 VDC or 24 VDC FACP
Order number 

Accessories
AL800LGK9E Logic Board
Replacement board used with the AL802‑WAL or
AL1002WAL NAC Power Extenders; mounts in
enclosure
Order number 

 

2 | AL1002WAL NAC Power Extender (10 A)