Makita ER2650LH ユーザーズマニュアル

Follow the instructions below during repairing.

• Wear glove to avoid injury. 

• Cool down the engine enough before repairing to avoid skin burn.

• Remove the remaining fuel in Tank and Carburetor completely. Note; No open flames in the workshop. 

• Repair the tool on the stable workbench and keep dust out.

• Record where and how the parts are assembled to avoid mis-assembling. And assort and keep the disassembled parts

   in the box by section. 

• Treat the disassembled parts carefully. Be sure to clean and wash parts before assembling.

• Use Impact driver if bolts and screws can not be loosen.

• Tighten the bolts and the screws to the specific torque as listed in Fig. 59.

• Check the movement and sound of the main parts by manually turning each part once assembled.

• Check the assembled parts by manually turning them if there is any faulty or unusual gap.

Code No.

Description

Use for 

Retaining ring pliers ST-2 for External ring removing/ assembling Retaining rings S-12 and S-24  

1R004

(1) Replace the removed gasket with the new one.

(2) Clean the matching surface where the gasket is placed to maintain its sealing performance. 

Air density tester

diagnosing Carburetor
removing / assembling M5 Hex socket head bolt

T-type hex. wrench 4-130

removing Clutch drum and Ball bearing 6001LLU

Round bar for arbor 20-100

1R247

1R171

1R127

press-fitting Clutch drum

Round bar for arbor 12-50

1R286

removing Flywheel

Flywheel puller

1R364

holding Cutter holder

Spring pin extractor 4.0

1R308

Wire brush

Adjusting Ignition coil, Spark plug and Rocker arm assembly
removing / assembling Flywheel

Hex socket bit 13

cleaning Spark plug

Feeler gauge set

1R366

---
---

(1) Apply Makita grease N No.2 to Spiral spring in Recoil starter and the spline ends of Shaft.

(2) Apply Liquid gasket; ThreeBond 1215, to the matching surface of

      Crank case and Cylinder block when assembled. (Fig. 55)

P  2/ 14