Makita EBH341U ユーザーズマニュアル

17

1.   Put off cover from housing, pressing two cover locking tabs located 

oppositely on side of the housing.

2.   Take off tap knob and spool from the housing.

3.   Put each one end of two cutting lines into each holes at inner most of the 

slot on one of spool outer flanges. Put the lines into spool gutters through 

each slit on the flanges.

4.   Wind the lines up firmly to the direction slown by left-hand (LH) arrow on the 

flange. Do not cross the lines.

5.   Wind all but about 100 mm (3-15/16”) of the Cords, leaving the end 

temporarily hooked through a notch on the side of the spool.

6.   Put tap knob onto the housing hub, positioning it can freely move up and 

down against spring tension. Put the spool into the housing, aligning the 

teeth on spool and tap knob alternately like gears.

Cover 

Locking 

Tab

Pull up

Housing Window

Tab knob

Spool

There is a hole inner 

most of the slit

Slit

To “LH” direction

Wind tightly

100 mm from 

notches

Tab knob’s Teeth

Spool’s Teeth