Havis C-3010 ユーザーズマニュアル
GENERAL ASSEMBLY & INSTALLATION INSTRUCTIONS
C-SERIES, C-AS-SERIES, & C-TM-SERIES CONSOLE KITS
HARDWARE: (C-HK) (Not all hardware is used in most applications)
QTY DESCRIPTION
QTY DESCRIPTION
PART #
12
¼” x ¾” Hex head bolt
GSM33001B
8
¼”x ½” Hex head bolt
GSM33000
4
¼” x ¾” Carriage bolt
GSM32000
4
¼” x ¾” Hex head lag
GSM33060-1
12
¼” Hex nut
GSM30005
4
¼” Serrated nut
GSM30023
16
¼” Flat washer
GSM31005
6
¼” Split lock washer
GSM31026
4
¼” Retaining washer
GSM31322
4
1/16” Nylon spacer
CM86600
TOOLS REQUIRED:
3/16” Allen wrench
Standard socket set
Metric socket set
Standard socket set
Metric socket set
Ratcheting wrench
Powered drill w/ drill bit set
Open-end wrench set
Powered drill w/ drill bit set
Open-end wrench set
Always!
Disconnect the vehicles’ battery. Removing seat bolts on some vehicles may give the vehicles
computer a false reading resulting in warning lights. This requires the vehicles’ computer to be
reset.
reset.
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit.
For product support, visit the Install Instructions Section of our website at
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit.
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html
, email
technicalsupport@havis.com
or call 1-800-
524-9900
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Remove front bolts on driver and passenger seats.
3. Loosely attach console-mounting brackets to the C-Series console following assembly drawing
2. Remove front bolts on driver and passenger seats.
3. Loosely attach console-mounting brackets to the C-Series console following assembly drawing
on page two. Assemblies will vary depending on console and trak length.
4. Determine location of Trak in relation to transmission hump bracket and assemble the two pieces
following assembly drawing.
Note: When mounting the Trak to the transmission hump bracket, be aware of the different patterns of
slots on each side. The side with the ¼” slots closer together is the side that is attached to the hump
bracket.
slots on each side. The side with the ¼” slots closer together is the side that is attached to the hump
bracket.