Gorenje RK60359OCH 444690 ユーザーズマニュアル

260437

Required tools: socket spanner nr. 8, screwdriver, torx 25.
Caution! After unscrewing of before fi xing hinges, hold the door 
to prevent it from falling and damaging.
1.  Remove upper hinge cover (save it for eventual later use), 

remove also the cover on the opposite side of the upper hinge 
cover (on the opposite side you will insert the attached cover 
during the assembly), and remove the cover on the opposite 
side of the upper part of the door.

2.  Unscrew upper hinge screws and remove the upper door from 

the middle hinge.

3. On the bottom side of the upper door unscrew the swing 

stopper screws and remove the stopper (A). Keep this for 
eventual use later on. Fix the attached stopper with its 
bearing on the opposite side of the door.

4.  Unscrew the forced door closure system (B) and fi x it to the 

opposite side of the door (certain models only).

5.  Unscrew middle hinge screws, remove the door  from bottom 

hinge.

6.  Loosen the screws fi xing the leg supports (certain models 

only), then continue the procedure either under cf. 7 or 7.1, 
depending on the model of the appliance.

7.  Tilt the appliance backward (max. 35°) to lean to the rear 

side of the cabinet. Unscrew the leg support screws (C) - left 
and right, and remove the leg support cover (D) and place it 
to the opposite side. Unscrew and remove, then reciprocally 
replace the position of end switch (E) and decorative peg (F) 
(for models with forced door closing system). Unscrew three 
screws fi xing the bottom hinge (save the hinge for later use), 
and fi x the attached bottom hinge on the opposite side.

7.1. Tilt the appliance backwards (max. 35°) to lean on the 

housing at the back.

 

Loosen three screws holding the bottom hinge (save the 
hinge for eventual subsequent door swing change). On the 
opposite side affi x the attached bottom hinge. Plug the holes 
left after the replacement with relevant pegs. 

8.  Repeat the procedure 3 and 4 on the bottom door. In case 

there is no bottom door limit peg, transfer the bearing (G) and 
washer to the opposite side of the door.  

9.  Proceed with the assembly procedure in opposite sequence.

Remark:
•  At OLD TIMER appliances alteration of door opening direction 

is not possible.

11