Cisco Aironet 2702i AIR-CAP2702I-E-K9 プリント
製品コード
AIR-CAP2702I-E-K9
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 11 of 25
Figure 3. RTS/CTS Enhanced with Bandwidth Signaling
For this reason, 802.11ac defines an enhanced RTS/CTS protocol. RTS/CTS can be used to determine when
First, when an 802.11ac device sends an RTS, (1) this initiating device has to verify that the 80-MHz channel is
clear in its vicinity, (2) the RTS is normally sent in an 802.11a Physical Protocol Data Unit (PPDU) format, and (3)
the basic 802.11a transmission, which is 20 MHz wide, is replicated another three times to fill the 80 MHz (or
another seven times to fill 160 MHz). Then every nearby device, regardless of whether it is an 802.11a/n/ac device,
receives an RTS that the device can understand on its primary channel. And every device that hears the RTS has
). To make the protocol robust, the replication bandwidth of the
RTS is reported inside the 802.11a PPDU.
1
1
Since the 802.11a PPDU format doesn’t contain a bandwidth indication, 802.11ac has to play some tricks to maintain backward
compatibility. The bandwidth indication is encoded in the scrambling sequence, and also the individual/group bit in the transmitter
MAC address in the RTS frame is changed from “individual” to “group." This last change will be visible in sniffer traces.
MAC address in the RTS frame is changed from “individual” to “group." This last change will be visible in sniffer traces.