zBoost YX052 プリント
©2013 zBoost.
Rev913
Ceiling Mounting the Base Unit Antenna
Once you have determined the desired location for
the antenna, mount the antenna using the
included hardware:
the antenna, mount the antenna using the
included hardware:
1)
Drill a ¾” diameter (19 mm) hole in the ceiling
where the antenna is to be mounted.
where the antenna is to be mounted.
2) Route the RF cable and threaded mount of the
antenna through the hole from the room side
as shown.
as shown.
3) Attach the plastic nut over the threaded
section extending through the ceiling and
hand-tighten the nut. Excessive force can
damage the threaded mount of the antenna.
hand-tighten the nut. Excessive force can
damage the threaded mount of the antenna.
4) Connect the RF cable of the antenna
to a 15’
coax extension cable (not provided). Then,
using the provided TNC-F adapter, connect
the coax to the Base Unit.
using the provided TNC-F adapter, connect
the coax to the Base Unit.
YX052: Omni-Directional Indoor Base Antenna
The directions below will assist you in the installation of the YX052 ceiling mount Omni-directional indoor
antenna. The antenna provides enhanced performance for the zBoost cell phone signal booster and is
compatible with consumer and commercial zBoost products.
antenna. The antenna provides enhanced performance for the zBoost cell phone signal booster and is
compatible with consumer and commercial zBoost products.
Mounting the Base Unit and Omni-Directional Antenna
The YX052 antenna provides enhanced signal strength in all
directions (omni-directional) from the antenna. The antenna should
be located near the center of the area where improved signal
strength is desired. The antenna requires a length of coax cable
(not included) to be able to connect to the Base Unit. It is
recommended to use 15’ of RG-6 cable, Part YX030-15W.
directions (omni-directional) from the antenna. The antenna should
be located near the center of the area where improved signal
strength is desired. The antenna requires a length of coax cable
(not included) to be able to connect to the Base Unit. It is
recommended to use 15’ of RG-6 cable, Part YX030-15W.
Specifications
Frequencies
700
– 2500 MHz
Gain
1 -2 dBi
Beamwidth
Omni directional
Polarization
Vertical
Dimensions
6.5”L x 6.5”W x 3.35”H
Weight
0.77 lbs
Connector
F Female
Mounting
Ceiling mount in ¾” diameter hole
Return Loss
>14 dB