Philips HDP1590 HDP1590/F7 ユーザーズマニュアル

1 Switch the device on using the on/off key.

2 After the initial screen the main menu appears.

3 Use the navigation keys to select Settings. 

4 Confirm with OK.

5 Use ¡/¢ to select from the following settings.

6 Confirm with OK.

7 Modify the settings using OK, ¡/¢, 

8 Confirm with OK. 

The ¿ key takes you one step back in the menu.

WiFi – switching the wireless network (WLAN) off and 
on.

Network Selection – select the wireless network with 
which the device is to connect.

WiFi Hot Spot – activate and deactivate WLAN teth-
ering.

LAN – switching the LAN network (LAN) off and on.

Advanced – (LAN mode only) check the Network 
actual IP address or change the address by inputting 
new address. You can also select Automatic or Use 
static IP

DLNA Sharing – switching DLNA off and on.

Bluetooth  – switching the Bluetooth connection off 
and on.

3D – set the picture modes with 2D/3D options.

Keystone – use ¡/¢ to set the keystone.

Fit Screen – use ¡/¢ to select the screen mode

Front – normal projection; the device is located in 
front of the projection surface/screen

Rear – rear projection; the device is located behind 
the projection surface; the image is reflected hori-
zontally.

Front Ceiling – the device is hanging from the ceiling 
in an upside-down position; the image is rotated by 
180 degrees.

Rear ceiling – the device is located behind the pro-
jection surface, hanging from the ceiling in an upside-
down position; the image is rotated by 180 degrees 
and reflected horizontally.

Wall color correction – colour correction of the pro-
jected image to adjust to coloured projection surfaces

Smart Settings – select predefined settings for bright-
ness / contrast / colour saturation. If you modify these 
settings, the setting is switched to Manual.

Brightness – use ¡/¢ to adjust the brightness and 
press OK to confirm.

Contrast – use ¡/¢ to adjust the contrast and press 
OK to confirm.

Colour temperature – set to Warm to enhance 
hotter colors such as red, or set to Cool to make 
picture bluish.

Smart Brightness – use ¡/¢ to adjust the smart 
brightness and press OK to confirm.

Dynamic contrast – adjusts the contrast to keep it 
at the best level according to the brightness of the 
screen.

Color space – to convert the color space setting to 
another standard.

Gamma – adjusts the gamma correction according 
to the type of the projected image.

Volume – adjust the volume

Deep Bass – switching the deep bass on and off

Wide sound – switching the wide sound on and off

Equalizer – select the equalizer mode

Smart volume – turn on/off the volume level automatic 
control function

Key beep – turn key tones on and off

Speaker – switching the speaker on and off

Date and time – set date and time

Android Settings – set Android system

Sleep mode – With this function, the projector auto-
matically goes to ECO mode after a specified period of 
time or at the end of a movie.

Auto Power Down – turn on/off the sleep mode.
The default setting is off. 

LU UST_EN_US.book  Page 29  Mercredi, 30. juillet 2014  9:22 09