Marmitek TM13 09574 プリント
製品コード
09574
TM13™
Plug type G Art. nr. 09196
Plug type U Art. nr. 09198
Plug type F
Art. nr. 09197
Plug type CH Art. nr. 09574
Plug type I
Art. nr. 09442
Europlug
Art. nr. 09745
Universal box size (LxWxH)
90 x 74 x 144 mm with euroslot
© MARMITEK
Smart Solutions at Home
www.marmitek.com
22792/20101004
Technical data
Also available
Set includes
Order information
Supply voltage
230V ±10% 50 Hz
Power consumption
< 1,5 Watt
Switching capacity
300W/230V for light bulbs and low-voltage halogen lamps
with a 500W/230V transformer for inductive / capacitive
loads 1200 W/230V for linear loads
Frequency 433.92
MHz
X-10 transmission
1 puls burst on 0˚ ,60˚ en 120˚
Transmission signal
120 kHz ± 2 kHz / 2.5 Vpk-pk
Signal sensitivity
15 mVpp min, 50 mVpp max at 120 kHz
X-10 Key codes
All Units Off, On, Off, Status Request
Input impedance
180 ohms (P–N) at 120 kHz
Visit www.marmitek.com for our complete product range.
1x User Manual
English, Deutsch Français,
Espanol, Italiano, Nederlands
Transmitters/Controllers
Din-rail Modules
Dimmers/Switchers
Micro Modules
Plug-in Modules
Build-in Modules
The TM13 responds to wireless Radio Frequency (RF) signals from any X-10 wireless remote controls or wireless wall switches. It re-transmits, over the house wiring, any signals it
receives from these wireless remote controls or wall switches. A built-in appliance switched outlet responds to X-10 signals received on the power line or to RF signals received from
any X-10 wireless remote controls. The TM13 responds to a serial control message in “STANDARD” X-10 format : “All units off” from any X-10 controller set to its house code regard-
less of unit code, or alternatively, by individual unit controller by “On” and “Off”. The TM13 can be polled for its status by the CM15Pro (two way universal computer interface) or
by any controller using the Extended X-10 format.
receives from these wireless remote controls or wall switches. A built-in appliance switched outlet responds to X-10 signals received on the power line or to RF signals received from
any X-10 wireless remote controls. The TM13 responds to a serial control message in “STANDARD” X-10 format : “All units off” from any X-10 controller set to its house code regard-
less of unit code, or alternatively, by individual unit controller by “On” and “Off”. The TM13 can be polled for its status by the CM15Pro (two way universal computer interface) or
by any controller using the Extended X-10 format.
TYPICAL APPLICATIONS
This is the general purpose unit for the smallest to largest applications. It can be a starter kit with an X-10 RF transmitter for remotely turning ON and OFF any appliance
This is the general purpose unit for the smallest to largest applications. It can be a starter kit with an X-10 RF transmitter for remotely turning ON and OFF any appliance
TM13™
1x TM13