MIPRO MTM-90 MTM 90(6A) ユーザーズマニュアル
製品コード
MTM 90(6A)
1.
Each storage holds 1 Bodypack transmitter.
2.
Procedures:
A. Before opening the storage.
B. Rotate the switch clockwise on the left to release the storage panel.
C. Move the storage panel slightly left then pull it out.
D.
Insert the upside down bodypack transmitter towards the back panel of storage
panel with antenna pointing to the front.
E. Push the bodypack transmitter gently into the storage panel. Be careful with
antenna placement.
F.
Rotate the switch counterclockwise to close the storage.
G.
Ascertain storage is not loose but rather a snug fit.
Select the MT-90/MT-92 module with proper frequency band
1.
The MT-90A/MT-92A transmitter amplifier must include the MT-90/MT-92 transmitter
module for operation, and the frequency band should be consistent with the
selected receiver. The output power of the MT-90A/MT-92A is several times larger
than the power of normal wireless microphone; as a result, it's needed to check if
the MT-90A/MT-92A will cause any interference to other wireless microphone
systems.
2.
When interference occurs, change the channel of MT-90/MT-92 module or use a
new MT-90/MT-92 module with different frequency band. The MT-90A/MT-92A can
properly operate with the MT-90/MT-92 transmitter module in UHF frequency band
from 600 MHz to 960 MHz.
RX
TX MIC
NOISE
AF
RF
CHANNEL
No.
SCAN
ACT
G
R
O
U
P
C
H
A
N
N
E
L
B
B
A
T
PO
WE
R
OFF
7A BAND
8A BAND
Different frequency band
Wireless
Interlinking
Transmitter
Operation and Cautions
3
4
Wireless Interlinking Transmitter
Wireless Interlinking Transmitter
How to store Bodypack transmitter
THIS DEVICE COMPLIES WITH PART74 OF THE FCC RULES AND RSS-123 ISSUE2 OF
CANADA. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device. This equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled environment.
& IC - ID
Disposal
2005-08-13
Dispose of any unusable devices or batteries responsibly and in accordance
with any applicable regulations.
with any applicable regulations.
Disposing of used batteries with domestic waste is to be avoided!
Batteries / NiCad cells often contain heavy metals such as cadmium(Cd),
mercury(Hg) and lead(Pb) that makes them unsuitable for disposal with
domestic waste. You may return spent batteries/ accumulators free of
charge to recycling centres or anywhere else batteries/accumulators are
sold.
mercury(Hg) and lead(Pb) that makes them unsuitable for disposal with
domestic waste. You may return spent batteries/ accumulators free of
charge to recycling centres or anywhere else batteries/accumulators are
sold.
By doing so, you contribute to the conservation of our environment!
A
B
C
D
F
E
G