Triotronik PRETERM 8G50 LC-LC OM3 300.0M ユーザーズマニュアル
49
www.lightwin.ch • t +41 62 530 29 26 • pa@lightwin.ch • office@lightwin.ch
Das Kabelmesser unter das benöti gte
Rohr drücken und herausholen
Put the knife under the pipe you want
to branche off
Rohrpfl ug in das zuvor
gemachte Loch platzieren
Mount the pipeplough
Den Spezialschneider unter das Rohr
drücken und durchschneiden
Put the cutt er under the pipe and cut.
Remember to put an endcap on the end
not in use
Mit dem Rohrpfl ug die Stelle einfach
aufschneiden
Cut open along the side - about 15cm
Mit Entgratungswerkzeug bearbeiten
The micropipe has to be bevelled.
It is important to bevelle both pipes
Der Schnitt sollte quadrati sch sein
Make a square opening in the jacket
Verbindungsmuff e draufdrücken
FERTIG
Mount the connector. Press the pipef
irmly into the connector unti l the lock
releases
For a Blown Fibre or Multi duct system you need expensive tools for turn off s.
With the Flatlinersystem you only need the cheap and easy-to-install connectors.
Ready in 2 minutes:
Bei einem „Blown Fibre“ oder Multi rohrsystem benöti gen Sie teure Muff en um Abzwei-
gungen vorzunehmen.
Mit dem Flatlinern benöti gen Sie nur einen günsti gen Abzweiger.
Das Ganze ist in 2 Minuten ferti g:
Blown Fibre
90 Minut
es
Flatliner
2 Minut
es
Multi duct
30 Minut
es
Mit dem Kabelmesser zwischen die 2
äußeren Rohre ein Loch machen
Put the knife between the two outer
pipes and push/turn gently a hole in
the jacket