Philips MC235B Micro Hi-Fi System MC235B/37 ユーザーズマニュアル
製品コード
MC235B/37
18
English
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or Philips for
help.
are unable to remedy a problem by following these hints, consult your dealer or Philips for
help.
Problem
Solution
CD OPERATION
“
NO DISC” is displayed.
– Insert a disc.
– Check if the disc is inserted upside down.
– Wait until the moisture condensation at the lens
– Check if the disc is inserted upside down.
– Wait until the moisture condensation at the lens
has cleared.
– Replace or clean the disc, see “Maintenance”.
– Use a finalised CD-RW or CD-R.
– Use a finalised CD-RW or CD-R.
RADIO RECEPTION
Radio reception is poor.
– If the signal is too weak, adjust the antenna or
connect an external antenna for better reception.
– Increase the distance between the Micro HiFi
System and your TV or VCR.
GENERAL
The system does not react when buttons
– Remove and reconnect the AC power plug and
are pressed.
switch on the system again.
Sound cannot be heard or is of poor
– Adjust the volume.
quality.
– Disconnect the headphones.
– Check that the speakers are connected correctly.
– Check if the stripped speaker wire is clamped.
– Check that the speakers are connected correctly.
– Check if the stripped speaker wire is clamped.
The left and right sound outputs are
– Check the speaker connections and location.
reversed.
The remote control does not function
– Select the source (CD or TUNER, for example)
properly.
before pressing the function button (
ÉÅ,í,
ë).
– Reduce the distance between the remote control
and the system.
– Insert the batteries with their polarities
(+/– signs) aligned as indicated.
– Replace the batteries.
– Point the remote control directly toward
– Point the remote control directly toward
IR sensor on the front of the system.
The timer is not working.
– Set the clock correctly.
– Press TIMER to switch on the timer.
– Press TIMER to switch on the timer.
The Clock/Timer setting is erased.
– Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
Troubleshooting