Sony Network Management Board BKMFW31 ユーザーズマニュアル
製品コード
BKMFW31
GB
6
FWD-50PX1: Loosen the two screws
located on the top and bottom of the
option adaptor. Use a slot screwdriver
to turn the screws counterclockwise,
and then remove the option adaptor
carefully.
option adaptor. Use a slot screwdriver
to turn the screws counterclockwise,
and then remove the option adaptor
carefully.
Preparations for Using the Networking Function
Preparations for
Using the
Networking
Function
Using the
Networking
Function
You can connect this device to the network
with the LAN cable (10BASE-T/
100BASE-TX).
This section describes the tasks that are
required for using the networking function
of this device.
with the LAN cable (10BASE-T/
100BASE-TX).
This section describes the tasks that are
required for using the networking function
of this device.
Installing this device
Before installation
• Before installation, make sure that the
power to all the equipment is off. To turn
the display completely off, press the 1
switch so that the display changes to
standby mode, then disconnect the power
cable from the wall outlet.
the display completely off, press the 1
switch so that the display changes to
standby mode, then disconnect the power
cable from the wall outlet.
• When you install this device, make sure
that the flat panel display is locked and
stable.
stable.
Follow the steps below to install this device
to the FWD-50PX1/50PX1N Flat Panel
Display.
to the FWD-50PX1/50PX1N Flat Panel
Display.
1
Remove the already installed option
adaptor (for FWD-50PX1) or the
panel cover (for FWD-50PX1N).
adaptor (for FWD-50PX1) or the
panel cover (for FWD-50PX1N).
VIDEO
S VIDEO
IN
OUT
IN
OUT
RL
AU
D
D
IO IN
VIDEO INPUT AD
APT
OR
CONTR
OL S
REMO
TE
IN
OUT
1
1
2
When the option slot is located
on the right side*
on the right side*
* The location of the option slot differs
depending on the model of the Display
Unit. Refer to the Instruction Manual of
the FWD series as well.
Unit. Refer to the Instruction Manual of
the FWD series as well.