Western Digital My Book World Edition II - 2TB WDG2NC20000E ユーザーズマニュアル

MY BOOK WORLD EDITION

USER MANUAL

GETTING STARTED – 5

The Capacity Gauge (inner LED) consists of six sections which illuminate in a 
clockwise direction to indicate space used on the drive. Each section represents 
approximately 1/6 (one sixth) of disk space. Because this drive is preformatted and 
contains software and utilities, the first section is illuminated upon installation.

•

—Connects to an open router, hub, or network switch port using an 

Ethernet cable.

•

—Connects an external USB hard drive.

•

—Connects to the supplied power adapter and cable.

Pressing the recovery button while powering up the device resets the admin user 
name and password to default without erasing shared folders or volumes. The 
recovery button also resets network configuration to DHCP (obtain an IP address 
automatically). Follow the instructions below to reset the device using the recovery 
button.

1. Turn off the device and disconnect all cables from the unit. 

2. Insert a paperclip or narrow tipped pen into the recovery slot on the back of the 

unit. Press and hold down the recovery button.

3. While continuing to hold down the recovery button, connect the power cable to 

the back of the unit.

4. Hold the recovery button down until 10 seconds after the power/activity LED 

lights on the front of the device, then release the button. The unit may take up to 
three minutes to boot up completely.

Note: The default user name is 

 and the default password is 

.

Steady

Power-on state or 
power-save mode

Outer LED ring rotating clockwise

Device in use

Alternate flashing between inner and outer LED rings

RAID degraded mode. 
See section 7 for drive 
replacement instructions.

Rotating inner LED ring which increments as the 
rebuild percentage increases

RAID rebuild mode

Simultaneous flashing of both inner and outer LED 
rings

Device is overheating. 
Shut down the My Book 
device.