Lecroy WSXS-SPIBUS TD WSXS-SPIBUS TD trigger and decoder extension Compatible with LeCroy WaveSurfer® oscilloscopes. WSXS-SPIBUS TD ユーザーズマニュアル
製品コード
WSXS-SPIBUS TD
Operator's Manual
919586 RevA
145
Using the MIPI M-PHY
Using the MIPI M-PHY Decode Option Overview
The MIPI M-PHY decode option defines the next-generation lowest physical layers of high-speed, source-
synchronous interfaces based on the MIPI Alliance specification.
synchronous interfaces based on the MIPI Alliance specification.
Note: Ask your local LeCroy representative for more information about any Serial Data Debug Solution
Protocols or Toolkits using the Contact LeCroy for Support (on page 199) topic.
Protocols or Toolkits using the Contact LeCroy for Support (on page 199) topic.
MIPI M-PHY Decode Setup Detail
For general information about using controls shown on the main Serial Decode dialog, refer to Accessing The D
and TD Supported Protocol Toolsets (on page 13).
and TD Supported Protocol Toolsets (on page 13).
MIPI
M-PHY
S
OURCE AND
C
LOCK
C
ONTROLS
,
B
ASIC
,
AND
L
EVELS
R
IGHT
-H
AND
D
IALOGS
Access the Serial Decode dialog by touching Analysis → Serial Decode on the menu bar.
Touch the corresponding Setup... button for your decode. The Decode Setup... along with a corresponding right-
hand dialog is shown.
hand dialog is shown.
Decode Setup and MPHY Decode dialogs include the following controls:
M-PHY Source and Clock Controls
Depending on your probing selection on the right-hand dialog, corresponding source controls are provided for
Ddiff (differential clock trace), or Dp (Data positive) and Dn (Data negative).
Ddiff (differential clock trace), or Dp (Data positive) and Dn (Data negative).