Ebro Winlog.Light SoftwareCompatible with ebro® EBI 20 data-logger, ebro® EBI 25 data-logger, ebro® EBI 40 data-logger 1340-2354 ユーザーズマニュアル
製品コード
1340-2354
19
ENGLISH
Start installation
When all installation requirements have been fulfilled, the
Setup-Assistant now installs the software completely.
When all installation requirements have been fulfilled, the
Setup-Assistant now installs the software completely.
In case of problems, the Setup-Assistant gives you correspon-
ding hints with suggested solutions. Be sure to observe the
messages of the Setup-Assistant on the monitor!
ding hints with suggested solutions. Be sure to observe the
messages of the Setup-Assistant on the monitor!
If everything has functioned without problems, then after
some time the Setup-Assistant will give the message that the
software was successfully installed and that the installation is
now completed.
After the installation of the software you only have to connect
the interface (write-/reading device) (see next page).
some time the Setup-Assistant will give the message that the
software was successfully installed and that the installation is
now completed.
After the installation of the software you only have to connect
the interface (write-/reading device) (see next page).
Installation of Software
Connecting Interface to computer
Write-/reading devices (Interfaces) are connected with the
computer over the USB (Universal Serial Bus). In order to con-
nect your interface with the computer, proceed as follows:
computer over the USB (Universal Serial Bus). In order to con-
nect your interface with the computer, proceed as follows:
●
Make sure that the installation CD is in the computer drive.
This contains control programmes (so called „drivers“)
which are necessary for the operation of the interfaces.
This contains control programmes (so called „drivers“)
which are necessary for the operation of the interfaces.
●
In case you are using an fourfold/eightfold interface, con-
nect this over the included net adapter to the power supply
and switch it on (switch lights up).
nect this over the included net adapter to the power supply
and switch it on (switch lights up).
●
Connect the interface with the help of the included USB
cable to the computer.
cable to the computer.
The operating system automatically recognizes whether there
are modifications to the USB and gives corresponding mes-
sages on the monitor screen.
are modifications to the USB and gives corresponding mes-
sages on the monitor screen.
Booklet_win_light:Booklet_winlogPharm_05_2006 06.12.2010 18:12 Uhr Seite 19