Dostmann Electronic Dostmann electronic Temperature Data Logger 5005-0105 データシート
製品コード
5005-0105
LOG100/110/CRYO
– Data logger
G
12
1. Introduction
Dear customer,
thank you very much for purchasing one of our products. Before operating
the data logger please read this manual carefully. You will get useful infor-
mation for understanding all functions.
Dear customer,
thank you very much for purchasing one of our products. Before operating
the data logger please read this manual carefully. You will get useful infor-
mation for understanding all functions.
1.1 General advice
• For cleaning the instrument please do not use an abrasive cleaner only a
• For cleaning the instrument please do not use an abrasive cleaner only a
dry or wet piece of soft cloth.
• Please store the measuring instrument in a dry and clean place.
• Avoid any force like shocks or pressure to the instrument.
• Do not use force to connect the probe or the interface plugs in. The inter-
• Avoid any force like shocks or pressure to the instrument.
• Do not use force to connect the probe or the interface plugs in. The inter-
face plug is different from the probe plug.
1.2 Before operation
• Before operating the instrument take the instrument out of the packag-
• Before operating the instrument take the instrument out of the packag-
ing. Check whether a full battery CR2032 (3 Volt) is already inserted.
Display
Display indication after key depression
indication
FS = Factory settings
• After inserting the battery the instrument displays for 10 seconds the actual
measurements, afterwards the instrument displays for 30 seconds “FS”, after
this the instrument turn off. The same procedure appear after pressing any
button.
this the instrument turn off. The same procedure appear after pressing any
button.
LOG100/110/CRYO
– Data logger
G
17
Logger
Battery
Factory settings
is recording
(total empty)
2.5 LED-Indication and Buzzer
• The two LED’s and the internal buzzer help you to understand all logger
• The two LED’s and the internal buzzer help you to understand all logger
information, several status modes and alarm indications.
• LED green:
The green LED flashes during the logger start and according to the measur-
ing interval if the standard settings hasn’t been changed.
ing interval if the standard settings hasn’t been changed.
• LED red:
The red LED flashes when Hi- or Lo-Alarm has been achieved.
• Buzzer:
The Buzzer rings when Hi- or Lo-Alarm has been achieved(if the buzzer is
not deactivated). The Buzzer also rings when the configuration has been
transferred successful from the PC to the Logger.
not deactivated). The Buzzer also rings when the configuration has been
transferred successful from the PC to the Logger.
• You can activate or deactivate both, LEDs and Buzzer by using the Software
DE-LOG-Graph.
2.6 USB-Port
• For readout or programming, the data logger must be connected via USB-
• For readout or programming, the data logger must be connected via USB-
cable with a PC.
• View from the front: On the left side there is the USB-port. The port is pro-
tected by a small white rubber cap. To operate the USB-port please remove
the rubber cap.
the rubber cap.
LOG100/110/CRYO
12
page
121023
Manual