Greisinger T-Logg 100 SET Temperature Data Logger 601881 データシート

E39.0.01.6C-01 

Operating instruction T-Logg 100 

Page 5 of 4

 
Notice: 
As soon as 

 appears at display, the battery needs to be replaced. If battery voltage power decreases 

continuously, data logging will be stopped (compare with operating status ‘

HALT

’). 

Available stored data remains in the memory and do not get lost. It’s possible to read the measuring data after 
replacement of the battery. 
 
Replacement: 
 
1.  Remove the 4 screws at the front of the logger with a 

small screwdriver and remove the cover from housing. 
 

2.  Take out the PCB and deposit it carefully beside the 

housing with the LCD display face down. Take care not 
to damage the gasket. 
 

3.  Push out the button cell carefully from socket (see 

picture at the top on the right). 
 

4.  Insert the new button cell (type CR 2032) with correct 

polarity in the socket (the positive pole is on the retaining 
bracket – see picture at the bottom on the right). 
 

5.  Reinsert the PCB correctly (LCD face up) into the 

housing (see picture in the middle on the right). 
 

6.  Reassemble the housing. Use the 4 screws to fix the 

cover again. 

 
 
 
 
 

 

Environmental Reference!  Empty and defective batteries must not be disposed in the 

regular domestic waste. 
Return the used batteries to an authorised battery 
collecting point or send the batteries directly to us 
(sufficiently stamped). 

 

 
 

_______________________________________________________________________________________________________________________
 

GREISINGER electronic GmbH 

Hans-Sachs-Straße 26 

Tel.: +49 9402/9383-0 

http://www.greisinger.de 

 D-93128 

Regenstauf 

Fax: 

+49 9402/9383-33 

eMail: info@greisinger.de