Mueller Licht Müller LichtIndoor panel mounted lamp 57024 Silver-grey, White 57024 ユーザーズマニュアル
製品コード
57024
5
EN
WARNING: The installation of this kit must comply with the standard and regulation in force.
Should you have any doubt, please seek advice from a professional electrician.
1.Safety instructions
• It is possible to use two type of cable for connection to the main supply:
-Rigid wire section 1.5mm min.
-Flexible cord type HO3VVH2-F 0.75 mm
•Please refer to the drawing for the minimum distance for installation (Fig. A)
• Always respect electrical specifications described on product label.
• The product is for indoor use onl
For the class I product, the earthing connection must be established during installation.
y.
• The light source of the product is non-changeable light diodes(LED).
Never try to disassemble the product, as the light diodes can cause damage to the eyes.
Additional requirement for Bathroom Installation
• Please refer to the rating plate on the product to know in which volume you can
install the item.
• IPx0: This product can be installed in dry premise only(Fig.C).
• IPx1 / IPx2 / IPx3/ IPx4 / IPx5
Recommended area for bathroom installation
Zones in grey: Forbidden installation
Other area: Allowed installation
• This product must be installed on closed ceiling.
• The electrical circuit must be protected with a 10A fuse.
• This product must be connected to a circuit protected by a residual current
protective device with rated residual operating current not exceeding 30mA.
Warning before installation
• Always disconnect from main supply.
• The luminary shall under no circumstances be covered with insulating matting
or similar material.
• Interconnection cables and supply cord should be kept away from the spot in
order to protect them from the high temperature of the product.
• Repairs should only be carried out by qualified person and using genuine spare parts.
Following Warnings only applicable for kit supplied with driver
• These spots can only be connected to the secondary of the driver supplied with this kit.
• The driver should be installed in ventilated areas far from heat source.
• The driver can only be used to supply the spots supplied in this kit.
Please use the supplied fixing screws to mount the driver
The cables and driver supplied in this kit must not be modified.
2.Installation Steps (Fig.B)
3.Servicing
3.Servicing
How to clean the product
• Clean the visible part of the bulb and the metal rim with a soft dust cloth
(could be lightly moisten if necessary).
• Never use alcohol, solvent or products of a similar nature.
• Wait until the product is completely dry before reconnecting it to the main supply.
4.Symbols explanation
This product must be disposed of at a designated collection
point for Electrical and Electronic waste.For more information,
contact your local city office or the shop where you purchased
the product.
Luminaires not suitable for covering with thermally insulating
material.
• The driver is protected against short-circuit and overload. In case of
short-circuit or overload, the driver stops the electric supply.
Once the issue is fixed, the driver will start again.
2
2
Class I appliance
Class II appliance