C&E FS20 Wireless transmitter unit FS20 S4UB 4-channel Max. range (open field) 50 m 57125 データシート
製品コード
57125
17
b) Using several transmitters
In the delivery state each transmitter in the FS20 wireless control system has its own, randomly
set house code.
set house code.
If you want to jointly control one or several receivers via different transmitters,
you first need to coordinate the transmitters’ house codes. The same house
code must be set for each transmitter.
you first need to coordinate the transmitters’ house codes. The same house
code must be set for each transmitter.
Make sure you coordinate or set this shared house code for all the
transmitters before programming the receivers for the first time, as the
associated house code is also sent to the receiver during this procedure.
transmitters before programming the receivers for the first time, as the
associated house code is also sent to the receiver during this procedure.
The transmitters’ channels are already set to the same addresses and only need to be changed
if required, for example, if you are using an extensive FS20 wireless control system with
numerous receivers/transmitters.
if required, for example, if you are using an extensive FS20 wireless control system with
numerous receivers/transmitters.
Please also see the example in section 6.
c) Timer function in 4-channel operation
Buttons ‘TA1’/‘TA2’ or ‘TA3’/‘TA4’ constitute a button combination for
programming a receiver’s timer function.
programming a receiver’s timer function.
Proceed as follows to program the device:
• Press and hold down the button that is assigned to the receiver.
• Press the other button of the button combination for one to five seconds (1s to 5s) and then
release it.
• Only afterwards should you release the button that you pressed first.
These steps apply to starting as well as to stopping the timer programming.
For information on how to program the timer, see the instructions in the receiver’s user manual.