Renkforce Digitale Funk-Wetterstation sw Wireless Weather Station E0303H2TPR データシート
製品コード
E0303H2TPR
40
Switching the Alarm Function On/Off
Repeatedly press the button „UP“ briefly to activate or deactivate the alarm function.
Repeatedly press the button „UP“ briefly to activate or deactivate the alarm function.
The corresponding symbols appear above the seconds display:
Symbol „
Symbol „
1
“:
Alarm function switched on with alarm time 1
Symbol „
2
“:
Alarm function switched on with alarm time 2
Symbol „
1
2
“: Alarm functions with alarm times 1 and 2 on
No display:
Alarm function off
Activate Snooze Function or Terminate Alarm
• The alarm signal is activated at the set alarm time and the bell symbol „
• The alarm signal is activated at the set alarm time and the bell symbol „
1
“ (for alarm
time 1) or „
2
“ (for alarm time 2) flashes.
• Pushing the button „SNOOZE/LIGHT“ (11) on the top of the weather station or the
button „SNOOZE“ (9) will interrupt the alarm signal for 5 minutes. During this time, the
bell symbol continues to flash. „Z
Z
“ also flashes to the left of the bell symbol.
Then the alarm signal is started again.
This procedure can be repeated several times.
• To terminate the alarm signal (or snooze mode), push another button than the two
buttons „SNOOZE/LIGHT“ (11) and „SNOOZE“ (9).
The alarm signal is automatically terminated after 2 minutes if no button is
pushed.
f) Selecting the Temperature Unit °C/°F
• Keep the button „MEM“ (8) at the weather station pushed (approx. 3 seconds) to switch
the temperature unit between °C (degrees Celsius) and °F (degrees Fahrenheit).
• At the outdoor sensor, open the battery compartment and push the button „°C/°F“
(16) to switch the temperature unit between °C (degrees Celsius) and °F (degrees
Fahrenheit).