Technoline Temperaturstation Alu Wireless Weather Station WS 8301 データシート
製品コード
WS 8301
4.
If the optional probe has been plugged to the dual channel transmitter,
the outdoor temperature should then be displayed on the Temperature
Station on channel 1 and 2. Also, the signal reception icon will be
displayed. If this does not
the outdoor temperature should then be displayed on the Temperature
Station on channel 1 and 2. Also, the signal reception icon will be
displayed. If this does not
happen after 2 minutes, the batteries will need
to be removed from both units and reset from step 1.
Note:
•
Channel 1 will show the reading from the internal sensor of the dual
channel transmitter; Channel 2 will show the reading sensed by the
probe. If the probe is not plugged to the transmitter, " - -" will be shown
on Channel 2.
channel transmitter; Channel 2 will show the reading sensed by the
probe. If the probe is not plugged to the transmitter, " - -" will be shown
on Channel 2.
•
In order to ensure sufficient 868 MHz transmission, the final position
between the Temperature Station and the transmitter should not be
more than 100 meters (see notes on “Positioning” and “868 MHz
Reception”).
between the Temperature Station and the transmitter should not be
more than 100 meters (see notes on “Positioning” and “868 MHz
Reception”).
When two transmitters are used
1.
User shall remove all the batteries from the Temperature Station and
transmitters and wait 60 seconds (if setting has been done with one
transmitter before).
transmitters and wait 60 seconds (if setting has been done with one
transmitter before).
2.
Insert the batteries into the first transmitter.
3.
Within 2 minutes of powering up the first transmitter, insert the batteries
into the Temperature Station. Once the batteries are in place, all
segments of the LCD will light up briefly. Then the indoor temperature
and the time as 0:00 will be displayed. If they are not shown on the LCD
after 60 seconds, remove the batteries and wait for at least 60 seconds
before reinserting them.
into the Temperature Station. Once the batteries are in place, all
segments of the LCD will light up briefly. Then the indoor temperature
and the time as 0:00 will be displayed. If they are not shown on the LCD
after 60 seconds, remove the batteries and wait for at least 60 seconds
before reinserting them.
4.
The outdoor temperature readings from the first transmitter (Channel 1
and 2) should then be displayed on the Temperature Station (if probe
and 2) should then be displayed on the Temperature Station (if probe
28