Keysight Technologies U1583BClip-on ammeter adapter 0.5 -400 A 32 mm U1583B ユーザーズマニュアル

The U1583B current clamp is a dual range 40 A and 400 A clamp-on AC current clamp. This U1583B current 

clamp is designed for Agilent handheld digital multimeter (DMM) and Agilent handheld oscilloscope. The 

BNC-to-banana plug is required to connect the current clamp with DMM. While for handheld oscilloscope, 

it needs to use with BNC connector.

For technical assistance, contact your nearest Agilent Sales Offi ce or visit the Agilent website at 

www.agilent.com/fi nd/assist for further information.

The CE mark is a registered trademark of the European Community.This CE mark 

shows that the product complies with all the relevant European Legal Directives. If 

it was accompanied by a year, it indicates the year the design was approved. This 

ISM device complies with Canadian ICES-001.
Product contains restricted substance(s) above the maximum value, with 40 yr 

Environmental Protection Use Period.

The CSA mark is a registered trademark of the Canadian Standards Association.

The C-tick mark is a registered trademark of the Spectrum Management Agency of 

Australia. This signifi es compliance with the Australia EMC Framework regulations 

under the terms of the Radio Communication Act of 1992.
This instrument complies with the WEEE Directive (2002/96/EC) marking 

requirement. This affi xed product label indicates that you must not discard this 

electrical/electronic product in domestic household waste.

Please use the Agilent U1583A current clamp only as specifi ed in this manual. Otherwise, the protection 

provided may be impaired. A WARNING identifi es conditions and actions that pose hazards to the user. A 

CAUTION identifi es conditions and actions that may be damaging to the equipment under test. To avoid 

possible electric shock, personal injury or damage to this instrument, ensure that you use the adapter 

safely, and refer to the guidelines below.

AC - Alternating Current

Range button in release mode. 

Range ~ 400 A, Output ~ 1 mV/A

Caution, risk of danger (Refer to the 

user’s and service guide for  details)

DC - Direct Current

Maximum allowable current 

measurement is  400 A

Ground

Category III 600V over-voltage protection

Double Insulation

Range button in lock mode. 

Range ~ 40 A, Output ~ 10 mV/A

Caution, risk of electric shock (Refer to 

the user’s and service guide for detail)

To be applied around or removed from 

un-insulated hazardous live conductors