Futaba 10J F4109 データシート

製品コード

F4109

Before use

NOTE: If you need to remove or replace the

transmitter battery, do not pull strongly on the

battery wires to remove it. Insert the connector

straight as shown.

NOTE: This plug is for charging HT5F1800B.

The other battery cannot be charged.

FT2F2100B is removed from a transmitter, and

charges with an exclusive charger(LBC-4E5).

INSTALLATION AND REMOVAL OF THE TRANSMITTER BATTERY

The T10J transmitter is designed to work with

either four (4) AA alkaline dry cell batteries,

or HT5F1800B/FT2F2100B battery pack, both

available separately. The transmitter batteries

used are a matter of personal preference. AA

Alkaline batteries are available at any local

hobby shop, grocery store, etc. A battery pack

will need to be purchased from a hobby shop.

Remove the battery BOX if you choose

to use the optional HT5F1800B/FT2F2100B

battery pack, which can be recharged from the

transmitter.

And "BATT TYPE" in a PARAMETER is

changed into "HT5F1800B : 5.0V FT2F2100B :

5.8V " .

WARNING

Be careful not to drop the battery.

Never disconnect the battery connector

from the T10J transmitter after

turning off the power until the screen is

completely blank and the transmitter has

shut down completely.

* Internal devices such as memories may be damaged.

* If there is any problem, the message "Backup Error"

will be shown the next time when you turn on the

power of the transmitter. Do not use the transmitter as

it is. Send it to the Futaba Service Center.

Do not connect any other chargers except

the special charger to this charging

connector.

The voltage drop characteristics of a

rechargeable battery and dry cell battery

are different. Change the battery alarm

voltage to 5.0V for the HT5F1800B and

to 5.8V for the FT2F2100B.

Battery cover

push and slide down