ConiuGo 700100107 EasyGuard II 700100107 ユーザーズマニュアル

製品コード

700100107

Revision 9.0

GSM Alarm & Telemetry systems

10. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_3
11. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_3
12. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_3
13. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_4
14. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_4
15. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_4
16. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_4
17. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_4
18. XXXXXXXXXXXX  X   XXXX XXX    X    XXXXXXXX      0   N   OUTPIN_4

Which connection shall be modified <0=back> ?

Example:

When unused or disconnected any digital input is in condition "1" and can be

switched to "0" for simple tests by connecting it to the extended ground ("

⊥

") of the

Module. In that case the "0" – as shown here on input no. 1 – has to be set in the

combination table in order to trigger (switch on) outpin_1.

No. D_In PP A_In Time GSM SMS HTime R NAME
1. 0XXXXXXXXXXX X XXXX XXX X XXXX 0 N OUTPIN_1

Running the program shows how the output reacts after an input impulse.

If you have connected a siren to the digital output of the GSM

module you have to make sure that it only will work for a maxi-

mum of three minutes. This is given by laws and has to be paid

with attention from your side.

<3> Voice / Data Connection

This voice or modem connection will be established by the modul itself. You are able

to define by which event this action is started (e.g. by an incoming SMS).

Connection settings – Voice / Modem connection
--------------
Nr. D_In PP A_In TIME GSM SMS HTime R Output NAME
1. XXXXXXXXXXXX X XXXX XXX X XXXXXXXX ---- - Voice communi.

Example:

When disconnected, a digital input is in condition "1" and can be switched to "0" for

simple tests by connecting it to the extended ground ("

⊥

") of the Ad module. The "0"

shown here on input no. 1, would trigger the action on the combination

table.