Cypress Semiconductor Cy8CKIT-050 Cy8CKIT-050B ユーザーズマニュアル
製品コード
Cy8CKIT-050B
CY8CKIT-050 PSoC® 5LP Development Kit Guide, Doc. # 001-65816 Rev. *E
13
3.
Kit Operation
The code examples in the PSoC 5LP Development Kit help you develop applications using the
PSoC 5LP family of devices. The kit is designed to develop precision analog applications using
PSoC 5LP. The board also has hooks to enable low-power measurements for low-power application
development and evaluation.
PSoC 5LP family of devices. The kit is designed to develop precision analog applications using
PSoC 5LP. The board also has hooks to enable low-power measurements for low-power application
development and evaluation.
3.1
Programming PSoC 5LP Device
The default programming interface for the board is a USB-based on-board programming interface.
To program the device, plug the USB cable to the programming USB connector J1, as shown in the
following figure.
To program the device, plug the USB cable to the programming USB connector J1, as shown in the
following figure.
Figure 3-1. Connect USB Cable to J1
When plugged in, the board enumerates as DVKProg5. After enumeration, initiate, build, and then
program using PSoC Creator.
program using PSoC Creator.
When using on-board programming, it is not necessary to power the board from the 12-V or 9-V DC
supply or a battery. The USB power to the programming section can be used.
supply or a battery. The USB power to the programming section can be used.
If the board is already powered from another source, plugging in the programming USB does not
damage the board.
damage the board.
The PSoC 5LP device on the board can also be programmed using a MiniProg3 (CY8CKIT-002). To
use MiniProg3 for programming, use the connector J3 on the board, as shown in
use MiniProg3 for programming, use the connector J3 on the board, as shown in
Note The MiniProg3 (CY8CKIT-002) is not part of the PSoC 5LP Development Kit contents. It can
be purchased from the
be purchased from the
.