Texas Instruments BQ3060EVM - BQ3060 SBS 1.1 Compliant Advanced Gas Gauge Battery Evaluation Module BQ3060EVM BQ3060EVM データシート
製品コード
BQ3060EVM
Hardware Connection
www.ti.com
To start charge or discharge test, connect PRES pin to PACK- pin to set SYS PRES state. To test sleep
mode, disconnect the PRES pin.
mode, disconnect the PRES pin.
Figure 9. bq3060 Circuit Module Connection to Cells and System Load/Charger
7.2
PC Interface Connection
The following steps configure the hardware for interface to the PC:
1. Connect the bq3060-based smart battery to the EV2300 using wire leads as shown in
Table 5. Circuit Module to EV2300 Connections
bq3060-Based Battery
EV2300
SMBD
SMBD
SMBC
SMBC
VSS
GND
2. Connect the PC USB cable to the EV2300 and the PC USB port.
The bq3060EVM-001 is now set up for operation.
10
bq3060EVM-001 SBS 1.1 Compliant Advanced Gas Gauge Battery
SLUU342 – October 2009
Management Solution EVM
Copyright © 2009, Texas Instruments Incorporated