Comparison of Noise Performance Between a FET Transimpedance Amplifier and a Switched Integrator,
Application Bulletin, Texas Instruments Literature Number

SBOA034

EVM WARNINGS AND RESTRICTIONS

It is important to operate this EVM within the input and output voltage ranges as specified in the table provided
below.

Input Range, V

S+

to V

–

10 V to 30 V

Input Range, V

10 V to 30 V NOT TO EXCEED VS+ or VS

–

Output Range, V

10 V to 30 V NOT TO EXCEED VS+ or VS

–

Exceeding the specified input range may cause unexpected operation and/or irreversible damage to the EVM. If
there are questions concerning the input range, please contact a TI field representative prior to connecting the
input power.

Applying loads outside of the specified output range may result in unintended operation and/or possible
permanent damage to the EVM. Consult the product data sheet or EVM user's guide (if user's guide is available)
prior to connecting any load to the EVM output. If there is uncertainty as to the load specification, please contact
a TI field representative.

During normal operation, some circuit components may have case temperatures greater than 30

C. The EVM is

designed to operate properly with certain components above 50

C as long as the input and output ranges are

maintained. These components include but are not limited to linear regulators, switching transistors, pass
transistors, and current sense resistors. These types of devices can be identified using the EVM schematic
located in the material provided. When placing measurement probes near these devices during operation, please
be aware that these devices may be very warm to the touch.

Mailing Address: Texas Instruments Post Office Box 655303 Dallas, Texas 75265

2004

–

2011, Texas Instruments Incorporated