Cypress Semiconductor CY3280-MBR3 ユーザーズマニュアル

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B

Hardware

Table 4-1

maps the device pins to the physical sensors on the kit.

4.3.2

PSoC 5LP

An onboard PSoC 5LP is used as a USB-I

C bridge for communicating with the PC host. It also sets

the operating voltage applied to the target device. The MBR3 device can be operated at either 5.0 V,
3.3 V, and 1.8 V. By default, the onboard PSoC 5LP USB-I

C bridge sets 3.3 V as operating voltage

for the MBR3 device. The PSoC 5LP connects to the USB port of the PC through a USB Mini-B con-
nector and to the I

C interface of the CY8CMBR3116 device.

PSoC 5LP is a true system-level solution, providing an MCU, memory, analog, and digital peripheral
functions in a single chip. The CY8C58LPxx family offers a modern method of signal acquisition, sig-
nal processing, and control with high accuracy, high bandwidth, and high flexibility. Analog capability
spans the range from thermocouples (near DC voltages) to ultrasonic signals. For more information,
refer to the

PSoC 5LP web page

and datasheet

Table 4-1. Pin Mapping on the Kit

Sensor

Device

Kit

CS0/PS0

CapSense button/proximity sensor, controls
GPO0

Connected to proximity loop on kit

CS1/PS1

CapSense button/proximity sensor, controls
GPO1

Routed to Arduino header; can be used for
external button/proximity sensor

CS2/Guard

CapSense button/guard sensor, controls
GPO2

Routed to Arduino header; can be used for
external button/guard sensor

CS3

CapSense button, controls GPO3

Used as button BTN1 on the kit

CS4

CapSense button, controls GPO4

Used as button BTN2 on the kit

CS5

CapSense button, controls GPO5

Used as button BTN3 on the kit

CS6

CapSense button, controls GPO6

Used as button BTN4 on the kit

CS7

CapSense button, controls GPO7

Routed to Arduino header; can be used for
external button sensor

CS8/GPO0