Cypress Semiconductor CY3280-MBR3 ユーザーズマニュアル

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B

51

5.

Configuration Files and Example Projects

This section documents the high-level design process to open, configure, generate, and apply con-
figuration files to the CY3280-MBR3 EVK using the EZ-Click 2.0 customizer tool. This kit provides
three sample configurations. Each sample configuration file has different  configuration settings,
demonstrating various kit and device features. By default, the kit is configured with the Water Toler-
ance sample configuration.

To use the sample configuration files, you need the EZ-Click 2.0 customizer tool, which is installed
along with the kit.

The EZ-Click configuration files and PSoC 4 host projects require administrator privileges if they are
run directly from the default install location (C:\Program Files\Cypress). If you do not have
administrator privileges, copy the Firmware folder from the default install location to any other loca-
tion on your PC and use the files.

Follow these steps to run the configuration files and verify the features. Before running any of the
configuration files, short pins 1 and 2 on J13 and J14. This is required to short the I

2

C communica-

tion lines (SCL and SDA) of the MBR3 device to the PSoC 5LP I

2

C lines.

The jumper J15 should be in setting C, as shown in 

.

Table 5-1.  Features in Configuration Files

LED Toggle

Four CapSense buttons, four LEDs, buzzer, and LED toggle

Proximity Detection

Four CapSense buttons, four LEDs, proximity loop, proximity LED, buzzer, and LED 
brightness

Water Tolerance

Four CapSense buttons, four LEDs, water tolerance, flanking sensor suspension (FSS), 
auto-reset