Cypress Semiconductor CY3280-MBR3 ユーザーズマニュアル

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B

74

6.

Advanced Topics

The PSoC 5LP on the CY3280-MBR3 EVK serves as a USB-I

2

C bridge, which can be used to com-

municate with USB-I

2

C software such as Bridge Control Panel. Bridge Control Panel (BCP) is

installed along with PSoC Programmer during kit installation. BCP works with I

2

C, SPI, and RX8

bridges, which communicate with slave devices. This application currently supports CY3240,
MiniProg3, FirstTouch, FirstTouchRF, True-TouchBridge, DVKProg1, and KitProg bridges.

The following steps describe how to use the USB-I

2

C bridge, which can communicate between BCP

and CY8CMBR3116 device.

1. Open BCP from Start > All Programs > Cypress > Bridge Control Panel <version number>.

2. Connect the CY3280-MBR3 EVK to your PC via a USB port using the USB cable.

3. Ensure that the I

2

C selection jumpers J13 and J14 are shorted between pins 1 and 2 to enable 

I

2

C communication between PSoC 5LP and the MBR3 device. Connect jumper J15 in setting C, 

as shown in 

4. Select the KitProg in the BCP to use the USB-I

2

C functionality. On successful connection, the 

‘Connected’ and ‘Powered’ tabs turn green, as shown in 

.

Figure 6-1.  KitProg USB-I

2

C Connected in Bridge Control Panel