Texas Instruments SRC4382 Evaluation Module (EVM) and USB motherboard SRC4382EVM-PDK SRC4382EVM-PDK データシート
製品コード
SRC4382EVM-PDK
www.ti.com
SN74LVC1G125
or Equivalent
0.1mF
T RX+
o
To RX-
From +5V Logic
(TTL or CMOS)
VDD33
5
2
3
1
4
SN74AVC1T45
or Equivalent
0.1mF
T RX+
o
To RX-
From +1.8V or +2.5V
CMOS Logic
+1.8V or +2.5V
5
VDD33
6
3
1
2
4
TRANSMITTER OUTPUT INTERFACING
1:1
0.1 F
m
TX+
TX-
3
2
1
XLR
Digital Output
110
B
W
alanced
110W
SBFS030C – JANUARY 2006 – REVISED SEPTEMBER 2007
The SRC4382 line receivers may also be driven directly from external logic or line receiver devices with TTL or
CMOS outputs. If the logic driving the line receiver is operated from +3.3V, then logic level translation is not be
required. However, if the external logic is operated from a power-supply voltage that exceeds the maximum
VDD33 supply voltage of the SRC4382, or operates from a supply voltage lower than +3.3V, then level
translation is required.
CMOS outputs. If the logic driving the line receiver is operated from +3.3V, then logic level translation is not be
required. However, if the external logic is operated from a power-supply voltage that exceeds the maximum
VDD33 supply voltage of the SRC4382, or operates from a supply voltage lower than +3.3V, then level
translation is required.
shows the recommended logic level translation methods, utilizing buffers and
level translators available from Texas Instruments.
Figure 87. CMOS/TTL Input Logic Interface
This section details the recommended interfaces for the SRC4382 transmitter line driver and CMOS buffered
outputs. Balanced and unbalanced line interfaces, in addition to optical transmitter and external logic interfacing,
will be discussed.
outputs. Balanced and unbalanced line interfaces, in addition to optical transmitter and external logic interfacing,
will be discussed.
For professional digital audio interfaces, 110
Ω
balanced line interfaces are either required or preferred.
Transformer coupling is commonly employed to provide isolation and to improve common-mode noise
performance.
performance.
shows the recommended transformer-coupled balanced line driver interface for the
SRC4382. The transformer is specified for a 1:1 turn ratio, and should exhibit low inter-winding capacitance for
best performance. To eliminate residual DC bias, a 0.1
best performance. To eliminate residual DC bias, a 0.1
μ
F capacitor is utilized for AC-coupling the transformer to
the line driver outputs. The coupling capacitor should be a surface-mount ceramic chip type with an X7R or C0G
dielectric.
dielectric.
Figure 88. Transformer-Coupled Balanced Output Interface
Unbalanced 75
Ω
coaxial cable interfaces are commonly employed in consumer and broadcast audio
applications. Designs with and without transformer line coupling may be utilized.
(a) illustrates the
recommended 75
Ω
transformer-coupled line driver interface, which shares many similarities to the balanced
design shown in
(b) illustrates the transformer-free line driver interface, which is commonly
used for S/PDIF consumer connections.
Copyright © 2006–2007, Texas Instruments Incorporated
45
Product Folder Link(s):