Microchip Technology ARD00330 データシート
2010 Microchip Technology Inc.
Preliminary
DS39979A-page 207
PIC18F87J72 FAMILY
REGISTER 18-5:
SSPCON2: MSSP CONTROL REGISTER 2 (I
2
C™ MASTER MODE)
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
GCEN
ACKSTAT
ACKDT
(1)
ACKEN
(2)
RCEN
(2)
PEN
(2)
RSEN
(2)
SEN
(2)
bit 7
bit 0
Legend:
R = Readable bit
R = Readable bit
W = Writable bit
U = Unimplemented bit, read as ‘0’
-n = Value at POR
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
bit 7
GCEN: General Call Enable bit
Unused in Master mode.
Unused in Master mode.
bit 6
ACKSTAT: Acknowledge Status bit (Master Transmit mode only)
1 = Acknowledge was not received from slave
0 = Acknowledge was received from slave
1 = Acknowledge was not received from slave
0 = Acknowledge was received from slave
bit 5
ACKDT: Acknowledge Data bit (Master Receive mode only)
(1)
1 = Not Acknowledge
0 = Acknowledge
0 = Acknowledge
bit 4
ACKEN: Acknowledge Sequence Enable bit
(2)
1 = Initiate Acknowledge sequence on SDA and SCL pins and transmit ACKDT data bit. Automatically
cleared by hardware.
0 = Acknowledge sequence Idle
bit 3
RCEN: Receive Enable bit (Master Receive mode only)
(2)
1 = Enables Receive mode for I
2
C™
0 = Receive Idle
bit 2
PEN: Stop Condition Enable bit
(2)
1 = Initiate Stop condition on SDA and SCL pins. Automatically cleared by hardware.
0 = Stop condition Idle
0 = Stop condition Idle
bit 1
RSEN: Repeated Start Condition Enable bit
(2)
1 = Initiate Repeated Start condition on SDA and SCL pins. Automatically cleared by hardware.
0 = Repeated Start condition Idle
0 = Repeated Start condition Idle
bit 0
SEN: Start Condition Enable bit
(2)
1 = Initiate Start condition on SDA and SCL pins. Automatically cleared by hardware.
0 = Start condition Idle
0 = Start condition Idle
Note 1:
Value that will be transmitted when the user initiates an Acknowledge sequence at the end of a receive.
2:
If the I
2
C module is active, these bits may not be set (no spooling) and the SSPBUF may not be written (or
writes to the SSPBUF are disabled).