Microchip Technology TDGL002 - chipKIT Uno32 Development Board TDGL002 TDGL002 情報ガイド
製品コード
TDGL002
chipKIT™ Uno32™ Jumper Settings
www.digilentinc.com
page 2 of 2
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
JP4
PWM/DIGITAL SELECT: Configures pin 10 on J5 to be used as a PWM
output or a Digital Input/Output.
output or a Digital Input/Output.
Pin 10 configured as a Digital
Input/Output
Pin 10 configured as a PWM output
JP5/JP7
SPI SELECT: Used to configure the chipKIT™ as either a Master or Slave
when using the SPI (Serial Peripheral Interface). The chipKIT™ board can
be connected to another device or even another chipKIT™ through the SPI
connector (J8).
when using the SPI (Serial Peripheral Interface). The chipKIT™ board can
be connected to another device or even another chipKIT™ through the SPI
connector (J8).
chipKIT™ configured as a SPI Master
chipKIT™ configured as a SPI Slave
For more information on SPI, please visit Wikipedia’s SPI page at:
http://en.wikipedia.org/wiki/Serial_Peripheral_Interface_Bus#Mode_Numbers
JP6/JP8
I
2
C/ANALOG PIN SELECT: Used to configure A4 and A5 for functionality as
an Analog input or to be used as I
2
C communication pins.
A4 and A5 on J7 are configured to
be used as analog inputs
A4 and A5 are configured to be used as
I2C communication lines (A4 – SDA, A5 –
SCL )
For more information on I
2
C, please visit Wikipedia’s I2C page at:
http://en.wikipedia.org/wiki/I2C