Insys GSM EASY 4.1 11-02-01-03-01.027 ユーザーズマニュアル

INSYS GSM 4.2 easy 

Configuration with the Software HSComm easy 

January 07 

 

31

 

The INSYS GSM 4.2 easy can store the SIM card PIN internally and automatically 
logs into the GSM network after being switched on. 
To enter, activate New PIN and enter the PIN. Instead of the digits, only * are 
displayed. The default setting is “0000”. When the INSYS GSM 4.2 easy has a 
stored PIN, the option PIN active is checked. 
A PIN stored in the INSYS GSM 4.2 easy is deleted by Delete PIN. This also enables 
the operation of SIM cards without PIN. 
PIN active 

indicates that a PIN is stored. Beneath, you will see the login state in the 

following format: 
GSM: registered

 

Ready for operation 

 

GSM network does not allow access  

 

SIM accepted but no access to GSM network 

  Radio contact to GSM network too poor Î relocate 

antenna position 

 

Enter PIN number of the SIM card and restart device 

 

PIN of the SIM card is locked after repeated false attempts. 
To unlock, the PUK, which you find in the contract 
documents of your GSM provider is required. Remove the 
SIM card and enter the PUK using the menu of any 
commercial mobile phone. Absolutely ensure afterwards 
that the correct PIN is stored in the INSYS GSM 4.2 easy. 

Entering the number of the SMS service center (SCN) of the own GSM network 
provider is required for sending alarm messages via SMS. Enter the number in 
international format (e.g. Germany:  +49...) .  
The number of the SMS service center for your SIM card can be found in the 
contract documents of your GSM provider. 

Incoming SMS messages are read out once every minute. Each SMS is checked for 
usability (configuration, query alarm input, setting control output) and possible 
validity (format, password, selective call acceptance). After processing, a response 
SMS is sent (if applicable) and the SMS is deleted from the storage location. 
Incoming SMS messages are optionally protected with the remote configuration 
password.