C&E PTC heater 30 m² Black/silver PTC-150A PTC-150A データシート

製品コード
PTC-150A
ページ / 8
Intended use
With the integrated heating module and the fan, the heater generates a warm air stream for 
heating. Two heat output levels (750 or 1500 W) as well as a fan function without heating can 
be selected with a rotating knob.
The product may only be used in dry, enclosed spaces.
Any use other than the one described above may damage the product. Moreover, this involves 
hazards such as short circuit, fi re, electric shock, etc. It is not allowed to modify or rebuild any 
part of the product! 
Always observe the safety instructions included in these operating instructions. Please read the 
operating instructions carefully and keep them.
This product complies with the applicable National and European requirements. All names of 
companies and products are the trademarks of the respective owner. All rights reserved.
Explanation of Symbols, Inscriptions

   This symbol indicates a health hazard, e.g. electric shock.

   The exclamation mark indicates specifi c risks associated with handling, function and 
use. 
  The „Hand“ symbol indicates special tips and instructions.
 
Never cover the product, risk of fi re!
 
 The product is only intended to be placed and used in dry and enclosed indoor 
rooms; it must not get damp or wet.
 
The product complies with the protection class II.
Package Contents
• Heater
• Operating Instructions
Safety Instructions


   The warranty will be void in the event of damage caused by failure to observe 
these safety instructions! We do not assume any liability for any consequen-
tial damage! 
 
 Nor do we assume any liability for material and personal damage caused by 
improper use or non-compliance with the safety instructions! The warranty 
will be void in such cases! 
 
a) In general
 
•  The unauthorised conversion and/or modifi cation of the product is not permitted 
because of safety and approval reasons (CE). Do not open/disassemble! Contains 
no customer-serviceable parts.
 
   Maintenance, adjustment or repair work may only be carried out by an expert/
authorised service centre which is familiar with the risks involved and the relevant 
regulations.  
 
• The product is constructed according to protection class II. 
 
•  The product is not a toy and must be kept out of the reach of children. Be spe-
cially careful if children are around. Children cannot see the danger arising from 
incorrect use of electrical devices. Children might try to push objects through the 
product openings, for example. There is a risk of a life-threatening electric shock! 
Furthermore, there is a high risk of injuries from the hot surfaces!
 
  Install the product so that it cannot be reached by children.
 
•  Do not carelessly leave the packaging material lying around since this may be-
come a dangerous toy for children.
 
•  Handle the product with care, it can be damaged by impacts, blows, or accidental 
drops, even from a low height. 


  b) Installation location
 
•  The product may only be used in dry, closed interiors, it must not get damp or wet! 
Never set the product up in the direct vicinity of a bathroom, a shower or a bathing 
tub or the like! There is a danger to life through an electric shock!
 
• Never place the heater directly underneath a wall socket.
 
•   Choose an appropriate location. It must be sturdy, big enough, level, stable and far 
away from infl ammable materials and items (e.g. curtains, furniture, doors, etc.). 
Maintain a minimum distance of 1.5 m.
 
   The heater is only suitable for placement on a horizontal, level, even and suf-
fi ciently big surface (e.g, fl oor).
 
•  The product must not be exposed to extreme temperatures, direct sunlight or 
strong vibrations. 
 
•  Never place the heater on an unstable or movable surface. Always place the 
heater in such a way that it cannot tilt or topple over. 
 
   A safety switch at the bottom of the heater automatically shuts off the heater when 
it is lifted off the fl oor or tips over. Never block this safety switch!
 
   Despite the safety switch there is a risk of fi re when the heater tips/falls over! 
Furthermore, this could result in personal injury or damage to the product.
 
•   Due to the weight of the heater and the radiating hot air, the heater should never be 
placed on valuable fl oor surfaces without adequate protection. This may not only 
result in scratch marks or pressure marks, but also in discolorations due to the hot 
air. 
 
•  Never use the heater in vehicles and similar moving objects or spaces; it is only 
suitable for use in buildings.
 
•  Unwind the mains cable completely during operation. The power cable must not 
be pinched or damaged by contact with sharp edges. Do not place any objects on 
the cable, and do not allow it to become kinked. Install the cable where no one 
can stumble over it and the plug is easily accessible. Do not install the mains cable 
under carpets or the like.
 
•  Do not operate the device in environments where there are high levels of dust, 
fl ammable gases, vapours or solvents. There is a danger of fi re and explosion!
 
c) Handling and operation
 
•  Never plug in or unplug the plug-in power unit with damp or wet hands. There is a 
risk of a life-threatening electric shock!
 
•  Never connect the device to the power supply immediately after it has been 
brought from a cold room into a warm one. The condensation that develops in 
such cases could damage the device or cause an electric shock! Allow the heater 
to reach room temperature fi rst. Wait until the condensation has evaporated. This 
might take several hours. Only after this the heater should be plugged into the 
power supply and put into use.
 
• Never operate the heater unsupervised.
 
•  Do not use the heater together with an additional timer, a remote switching device 
(e.g. remote controlled socket) or similar devices, which automatically switch on 
the heater. There may be a risk of fi re if the heater is covered or installed in the 
wrong place.
 
•  Do not connect the heater to an extension cord or dimmer or the like. Directly plug 
the power plug into a wall socket for example.
 
•  When using the heater for the fi rst time, hot parts of the case may cause an irritat-
ing odour for a while. If you experience this, ventilate the room where the heater is 
set up. 
 
•  Always pull the mains plug on the gripping surface intended for this purpose. 
Never unplug the mains plug from the mains socket by pulling the cable!
 
•  Unwind the mains cable completely during operation. If the cable is not unwound 
completely, it can cause overheating; danger of fi re!
 
•  Do not use the product when it is damaged (e.g. housing, mains cable). A defec-
tive connecting cable may only be replaced by a specialist. There is a risk of a 
life-threatening electric shock!
 
•  Always pull the mains plug out of the mains socket before cleaning the heater, or 
when the heater is not to be used for a while.
 
•  Always leave suffi cient space from combustible or fl ammable materials or objects 
(curtains, doors, furniture etc.). If the distance is too small, there is a risk of fi re. 
Never operate the heater inside cabinets or other small enclosed spaces. Fire 
hazard!
 
   Never cover the heater, do not place clothing items or other objects on the heater. 
Never block the air inlet/outlet! There is a danger of overheating and fi re!
 
   O P E R A T I N G   I N S T R U C T I O N S   www.conrad.com
PTC Heater “Cube” 1500 W
 Item no. 55 13 08
 Version  09/11