Insys WLAN Bridge 11-02-01-06-03.001 ユーザーズマニュアル

製品コード

11-02-01-06-03.001

Command Overview INSYS WLAN serial

Command Description
ATU

Select UDP mode

For the next connection ATU selects the UDP mode. This setting applies to ATD
commands without a specific protocol (e.g. ATD192.168.100.200:1234 or for
incoming calls.

AT*U

Select data format

AT*U

sets the data format at the serial interface.

The following data formats (data bits, parity, stop bits) are supported:
AT*U0

8N1

(default)

AT*U1

7E1

AT*U2

7O1

AT*U4

7E2

AT*U5

7O2

AT*U6

7N2

AT*U7

8E1

AT*U8

8O1

AT*U9

8N2

ATV

Select message format (short or long format)

ATV

sets the format for responses. When ATV1 (default) is set, the messages are

displayed in clear texts; for ATV0 the message numbers are displayed (see table of
message numbers below)

AT&V

Display settings and connection statistics

AT&V0

displays the current and saved settings of the module.

AT&V1

Displays the diagnostic data of the last connection (connection partner,
reason for disconnect).

AT&W

Save settings

AT&W

saves all current settings in the permanent memory. The settings are restored from

this permanent memory, when the module is switched on.

The following AT settings are stored:

AT&C

, AT&D, ATE, AT&K, AT&O, AT#QUIET, ATS0, ATS8, AT*S, AT&S, AT*U,

ATT, ATU, ATV.

AT#WEL

Switch WEP on and off

AT#WEL

off (default)

AT#WEL

=1 on

The setting AT#WKY is immediately stored in the permanent memory (independent from
the command AT&W). The setting will only take effect with Reboot (AT#RBT).

AT#WKL

Length of the WEP key

AT#WKL

64 bit

AT#WKL

=1 128

bit

(default)

The setting AT#WKY is immediately stored in the permanent memory (independent from
the command AT&W). The setting will only take effect with Reboot (AT#RBT).

version 1.01 / 10.04