Fluke , 9 Hz thermography camera, , 80 x 60 pix bolometer matrix 4416293 ユーザーズマニュアル
製品コード
4416293
Ti90, Ti95, Ti100, Ti105, Ti110, Ti125, TiR105, TiR110, TiR125
Users Manual
Users Manual
28
TiR-Mode
Applies to: Ti105, Ti110, Ti125
TiR-Mode (thermal sensitivity) expresses the ability of an infrared camera to
display a very good image even if the thermal contrast in a scene is low. A
camera with good sensitivity can distinguish objects in a scene that have very
little temperature difference between them.
display a very good image even if the thermal contrast in a scene is low. A
camera with good sensitivity can distinguish objects in a scene that have very
little temperature difference between them.
Sensitivity is most often measured by a parameter called Noise Equivalent
Temperature Difference or NETD. NETD is defined as the amount of infrared
radiation required to produce an output signal equal to the system’s noise. The
noise rating of the system should be as low as possible.
Temperature Difference or NETD. NETD is defined as the amount of infrared
radiation required to produce an output signal equal to the system’s noise. The
noise rating of the system should be as low as possible.
To adjust the TiR-Mode:
1. Push .
2. Push / to highlight Image.
3. Push or to view the menu.
4. Push / to highlight TiR-Mode.
5. Push or to view the menu.
6. Push / to change the value.
7. Push:
• to set the change and go back to the live view.
• or to set the change and go back to the previous menu.
• to cancel the change and go back to the live view.
• or to set the change and go back to the previous menu.
• to cancel the change and go back to the live view.
When TiR-Mode is turned on, images are enhanced with the improvement to
the image clarity of live scan targets. This mode is used for building envelope
applications such as roofing, restoration, and remediation. Response times in
this mode increase (slower refresh rate) and the maximum temperature range
is lower.
the image clarity of live scan targets. This mode is used for building envelope
applications such as roofing, restoration, and remediation. Response times in
this mode increase (slower refresh rate) and the maximum temperature range
is lower.
Note
When on, the TiR-Mode is more likely to show blurring when the target
moves. Image enhancement cannot be applied to images after they
are taken.
moves. Image enhancement cannot be applied to images after they
are taken.