Keysight Technologies U1561A データシート
5
Noise peak-to-peak
3% of full scale or 5 mV, whichever is greater
DC vertical offset accuracy
± 0.1% div ± 2 mV ± 0.5% offset value
Single cursor accuracy
4% full scale
Dual cursor accuracy
4% full scale
Horizontal System
Range
U1602B: 50 ns to 50 s/div
U1604B: 10 ns to 50 s/div
U1604B: 10 ns to 50 s/div
Resolution
U1602B: 2 ns
U1604B: 400 ps
U1604B: 400 ps
Reference position
Left, center, right
Delay range (pre-trigger)
15 divisions
Delay range (post-trigger)
1000 divisions
Analog
Dt accuracy
± 3% reading ± 0.4% screen
Modes
Main, XY, Roll
RMS Jitter
5% of horizontal scale or 5 ns, whichever is higher
Trigger System
Source
Channel 1 and Channel 2
Modes
Auto, normal, single
Selections
Edge
Edge
Pattern
Pulse Width
Video
Edge, pulse width, pattern, video
Trigger on a rising or falling edge of any source
Trigger on a rising or falling edge of any source
Trigger at the beginning of a pattern of high, low levels and rising or falling
edge established conditions of AND, OR, NOR and NAND between the
channels.
edge established conditions of AND, OR, NOR and NAND between the
channels.
200 ns to 10 s. Trigger when a positive or negative pulse width of any source
larger than, less than, equal to or not equal to duration.
larger than, less than, equal to or not equal to duration.
Video trigger sensitivity: 0.7 division trigger level.
Available to both Channel 1 and Channel 2.
Analog progressive and interlaced video standards including NTSC,
PAL and SECAM.
Positive or negative sync pulse polarity.
Modes – all fi elds, even fi elds, odd fi elds or line 5 – 263 within a fi eld.
Available to both Channel 1 and Channel 2.
Analog progressive and interlaced video standards including NTSC,
PAL and SECAM.
Positive or negative sync pulse polarity.
Modes – all fi elds, even fi elds, odd fi elds or line 5 – 263 within a fi eld.
Range
± 4 divisions from center screen
Level accuracy
± 0.5 divisions
Trigger sensitivity
DC to 5 MHz: 0.8 divisions
U1602B: 5 MHz to 20 MHz – 1 division
U1604B: 5 MHz to 40 MHz – 1 division
U1602B: 5 MHz to 20 MHz – 1 division
U1604B: 5 MHz to 40 MHz – 1 division
Coupling
DC, AC (< 1 Hz), HF reject (> 50 kHz), LF reject (< 30 kHz), Noise reject
Probe attenuation factors
1x, 10x, 100x
Coupling
3 Vp-p, ~ 1 kHz
Maximum probe input
1x CAT III 300 VAC
10 x, 100x CAT III 600 VAC
10 x, 100x CAT III 600 VAC
Probes
U1560-60001: 1:1 passive probe
U1561-60001: 10:1 passive probe
U1562-60001: 100:1 passive probe
U1562-60001: 100:1 passive probe